Flotec FP4122 3/4 HP Cast Iron Shallow Well Jet Pump
If your home relies on a shallow well, the Flotec FP4122 is built to keep water flowing reliably day after day. This 3/4 HP cast iron jet pump is designed for wells with water depths of 25 feet or less, delivering strong, consistent pressure for households that depend on steady water supply for everyday use. The rugged cast iron housing stands up to years of demanding service, making it a smart choice for homeowners who want dependable performance without constant maintenance worries.
What makes the FP4122 especially convenient is its dual voltage motor, which is ready to install at 230 volts right out of the box, with the option to convert to 115 volts using the included manual. This flexibility means the pump can adapt to your home's existing electrical setup rather than forcing you to rework your wiring. With a 1-1/4 inch NPT suction size and a 1 inch NPT discharge size, it's engineered to move a strong volume of water efficiently from your well to your home.
Whether you're replacing an aging pump or setting up a new well system, the Flotec FP4122 offers the kind of straightforward, heavy-duty performance that homeowners have trusted for years. It's a practical, no-nonsense solution built to handle the everyday demands of shallow well water supply.
Key Features:
- Rugged, heavy-duty cast iron pump housing for long-term durability
- Dual voltage motor, ready-to-install at 230V with 115V conversion available
- Superior performance at water depths of 25 feet or less
- Factory-preset pressure switch setting of 30/50 PSI
- Self-priming design for straightforward installation
Applications:
- Residential shallow well water supply systems
- Homes and cabins relying on a private well for domestic water
- Replacement pump for aging or failing shallow well jet pumps
- Rural properties requiring dependable water delivery
Specifications:
- Horsepower: 3/4 HP
- Voltage: 115V / 230V, 60 Hz
- Maximum Capacity: 14.7 GPM
- Flow at 10' Lift and 40 PSI: 12.8 GPM
- Maximum Lift: 25 feet
- Maximum Pressure: 70 PSI
- Pressure Switch Setting: 30/50 PSI
- Amp Draw (Full Load): 6.1 amps at 230V / 12.2 amps at 115V
- Recommended Breaker: 15 amp (230V) / 20 amp (115V)
- Maximum Water Temperature: 140°F (60°C)
- Suction Port Size: 1-1/4" NPT
- Discharge Port Size: 1" NPT
- Body Construction: Cast Iron
Frequently Asked Questions
Q: Can the Flotec FP4122 be used on a deep well?
A: No, this pump is designed specifically for shallow wells where the water level is 25 feet or less from the surface. Deeper wells require a different pump type, such as a submersible or deep well jet pump.
Q: Does the FP4122 come pre-wired for 115V or 230V?
A: The pump arrives ready to install at 230 volts. If you need 115 volt operation, the motor can be converted following the instructions provided in the included manual.
Q: Is a pressure tank required with this pump?
A: Yes, a pressure tank is typically needed to maintain consistent water pressure and reduce the frequency of pump cycling, though it is sold separately.
Q: How loud is the Flotec FP4122 during operation?
A: Like most cast iron jet pumps, it produces moderate motor noise typical of shallow well pumps, so many homeowners install it in a basement, utility room, or pump house to minimize sound in living areas.
Q: What maintenance does this pump require?
A: Routine maintenance is minimal, but it's good practice to periodically check the pressure switch, inspect fittings for leaks, and ensure the motor and housing stay clean and free of debris.
CLRMarine
