BURKS 5CT7M, TURBINE PUMP 1/2HP 1PH 115/230V
Bronze Fitted Cast Iron Construction.
Close Coupled to a 1/2 Horsepower, 3450 RPM, 115/230 Volts, 1 Phase Motor.
Ports are 1 Inches NPT Inlet, 1 Inches NPT Outlet.
FEATURES
Cast Iron/Bronze/ Stainless Steel construction
Low Flow - High Pressure
FOUR POSITION CASING
Discharge can be located in any of four positions.
Casing is close grain iron of 30,000 psi minimum tensile strength. Back pull-out design eliminates the need to disturb piping should the pump ever require service - the casing stays in the line.
ENCLOSED BRONZE IMPELLER
Of the latest hydraulic design for maximum efficiency, impeller is balanced for vibration-free operation and threaded onto stainless steel motor shaft.
ENCLOSED GLASS FILLED NORYL® IMPELLER
Of the latest hydraulic design for maximum efficiency, impeller has molded in brass insert threaded onto stainless steel motor shaft. *Noryl® Impeller is not designed for use with hydrocarbons.
MECHANICAL SHAFT SEAL
Standard self-adjusting shaft seal for temperatures to 225°F (107°C) and pressures to 150 psi (1034 kpa).
Ceramic seat and carbon seal face for long trouble-free service.
Special seals are available for higher temperatures and fluids other than water.
MOTORS
Standard pump motors are of open drip proof (ODP) construction and are rated with jet pump service factors for continuous duty operation. Motors are 56 frame size with NEMA standard mounting flange, one piece threaded stainless steel shaft and ball/ball bearing construction.
FACTORY TESTED
After careful assembly and inspection, EVERY pump is factory tested and meets Hydraulic Institute standards.
UNSPSC Code: 40150000
CLRMarine
