Burks 09928-6.25 Bronze Impeller 6.25 in for G6-1-1/2 and G6-2
The Burks 09928-6.25 is a bronze replacement impeller measuring 6.25 in diameter, built for G6-1-1/2 and G6-2 pumps. It is the rotating heart of the wet end, and its condition sets the ceiling on what the whole pump can deliver.
Two things end an impeller. Abrasive wear rounds off the vane tips and opens the clearance to the casing, so more and more liquid recirculates instead of leaving through the discharge. Cavitation does something different and uglier, collapsing vapour bubbles against the vane surface until the metal looks pitted and eaten away. Both show up as falling flow and a pump that has to run longer for the same result.
Because Burks trims this casting to several diameters to suit different duty points, the size in the part number is not optional detail - it is what separates this impeller from its siblings. Measure the old one across the outside of the vanes if there is any doubt, and check that the pump is a G6-1-1/2 and G6-2 model.
Key Features
- Genuine Burks replacement impeller in bronze
- 6.25 in diameter - the dimension that sets the duty point
- Direct fit for G6-1-1/2 and G6-2 pumps
- Restores the running clearance that erosion opens up
- Returns flow and discharge pressure toward the original curve
- No modification, machining or rebalancing needed
Applications
- Burks G6-1-1/2 and G6-2 pump rebuilds
- Recovering flow and head that have fallen away slowly
- Replacing an impeller with eroded or chipped vanes
- Repairing cavitation pitting on the vane faces
- Restoring balance after a foreign object strike
- Industrial, agricultural, marine and dockside installations
Specifications
- Brand: Burks
- Manufacturer: Crane Pumps and Systems
- Manufacturer Part Number: 09928-6.25
- Part Type: Impeller
- Material: Bronze
- Size: 6.25 in diameter
- Fits: Burks G6-1-1/2 and G6-2
- Pump Speed: 1750 RPM
- Condition: New
Frequently Asked Questions
Q: Does the material matter if I have the right size?
Yes. Bronze is what Burks specified here, and the material sets the corrosion resistance, the stiffness of the vanes and the thermal expansion of the part. Substituting a different material in the same diameter can change both pump life and liquid compatibility.
Q: How do I confirm the diameter on the impeller I have now?
Measure across the outside of the vanes at the widest point with the impeller off the shaft. Burks quotes a nominal size, so a reading a few hundredths under is normal on a part that has seen service and does not by itself mean you have the wrong number.
Q: Can I fit a larger diameter to get more pressure?
Only within what the pump and motor were designed for. A bigger impeller draws more power and can overload the motor, raise the axial thrust on the bearings and push the casing past its rating. Stay with the diameter the pump was built around unless Burks lists the larger one for your exact model.
Q: What else is worth changing while the wet end is open?
The casing gasket or O-ring, because it is already disturbed, and the mechanical seal if the pump has any hours on it. The impeller lock screw and washer are cheap and awkward to reach a second time, so most rebuilders replace those at the same time.
Not sure this is the right part? Send us a Picture of the pump plate on your pump and the CLR Marine team will confirm the correct impeller before you order.
CLRMarine
