Globe 01-12-1600 Impeller
The Globe 01-12-1600 is a genuine Globe Composite Solutions Run-Dry impeller, cross-referenced to fit the raw-water pumps built for a wide range of marine and industrial engines.
Globe's Run-Dry construction resists swelling, shrinking, and abrasion far better than standard neoprene, and tolerates brief dry running with minimal wear — a common cause of premature impeller failure on raw-water pumps.
Key Features
- Genuine Globe Composite Solutions Run-Dry impeller
- Advanced composite elastomer construction resists swelling, shrinking, and abrasion
- Self-lubricating, thermo-set design tolerates brief dry running with minimal wear
- Precision-molded vanes for accurate factory fit
Applications
- Raw-water cooling pump impeller replacement on the engines and pumps listed in the cross-reference below
- Marine diesel and gasoline engine raw-water cooling systems
- Industrial and agricultural water pump service
Cross-Reference / OEM Fitment
Replaces: the following impellers Jabsco 12977-0001 Onan 131-0160, 131-02189 KIT, 132-0114
Specifications
- Manufacturer Part Number: 01-12-1600
- Weight: 0.3 lbs.
- Outer Diameter: 1 9/16" / 40
- Width: 3/4" / 19
- Shaft Size: 5/16" / 8
- Drive Type: Single Flat
- Core Type: Composite
- Number of Blades: 6
- Silhouette Letter: B
- Liquid/Fuel Type: Water
- Brand: Globe Composite Solutions
Frequently Asked Questions
Q: Does this impeller come with a gasket or O-ring?
Most Globe impellers ship with the matching housing gasket or O-ring included; check the specifications above to confirm for this part number.
Q: Should I lubricate the impeller before installing it?
Yes, a light coat of water-based lubricant (such as glycerin or dish soap) on the vanes makes installation easier and protects the impeller on first start-up.
Q: Is this a genuine Globe Composite Solutions part?
Yes, this is a genuine Globe Composite Solutions Run-Dry impeller, not a generic substitute.
Q: Will this impeller fit my pump?
Please compare the manufacturer part number and dimensions above against your pump plate or existing impeller before ordering, or send us a photo of your pump plate and we'll confirm.
Not sure this is the right part? Send us a picture of the pump plate on your pump and the CLR Marine team will confirm the correct part.
CLRMarine
