AMT 2105-006-01 Machined Stainless Steel Impeller
The AMT 2105-006-01 is the genuine machined stainless steel impeller for AMT’s 0.56 HP three-phase pump build, carried under the factory designation "Impeller XSS 0.56HP 3PH Mach". The "machined" designation is the detail that distinguishes it from otherwise similar castings in the same family — the bore, hub and vane faces are finish-machined to the drawing rather than left as-cast.
That finishing work is what lets the impeller hold a tight, repeatable running clearance against the casing, and running clearance is where a centrifugal pump’s efficiency lives or dies. Every thousandth of extra gap is liquid recirculating around the impeller instead of leaving through the discharge — the pump draws the same power but delivers less head and less flow. A finish-machined impeller starts its life at the tight end of that range.
Fit a new impeller when the vanes have thinned or gone ragged at the tips, when erosion has opened the clearance, or when cavitation has left pitted, spongy-looking damage on the vane backs. Stainless steel handles corrosive and salt-laden duty far better than iron or bronze. Because AMT builds several impellers of the same nominal rating with different finishes and hub configurations, confirm the part number against your parts breakdown before ordering.
Key Features
- Genuine AMT (Gorman-Rupp) service part — finish-machined to the original drawing
- Stainless steel construction for corrosion resistance and vane edge retention
- Machined bore, hub and vane faces for a tight, repeatable running clearance
- Matched to the 0.56 HP three-phase build
- Direct replacement — no balancing or fitting work required
Applications
- AMT pumps built on the 0.56 HP three-phase specification
- Restoring efficiency lost to an opened-up running clearance
- Replacing a worn, eroded or cavitation-damaged impeller
- Corrosive, salt-laden and washdown service
- Marine, dockside, dewatering and general water transfer equipment
Specifications
- Brand: AMT (Gorman-Rupp)
- Manufacturer Part Number: 2105-006-01
- Part Type: Impeller, finish-machined
- Material: Stainless steel
- Rated For: 0.56 HP, three-phase
- Factory Designation: Impeller XSS 0.56HP 3PH Mach
- Quantity Used Per Pump: 1
- Condition: New
Not sure this is the right part? Send us a Picture of the pump plate on your pump and the CLR Marine team will confirm the correct impeller before you order.
CLRMarine
