|
BURKS 23286-4.97, Wet End Kits for Series GA5-1-1/4
Pump kit Only* for all GA5-1-1/4 Series (*no motor – full sized impeller – impeller trim required). Catalog # 23286-4.97 For assembly on motor with a 56J Nema frame Motor (check motor specs.). Full size impeller is 4.97 Inches Diameter.
NOTE : Impeller diameter must be trimmed to suit Horsepower or previous Impeller diameter.
|
884.70 |
|
|
AMT Pump 4861-97 Brz Centrifugal Pump 12V
1/8 HP, Totally Enclosed, Not Ventilated, 12 volt DC electric motor
Salt water resistant Naval Bronze construction
Semi-open, self-cleaning impeller that can handle solids to 3/16 inch diameter
Buna-N mechanical seal and O-ring
The AMT 4861-97 is a lightweight 12 volt pump that is designed for use in live tanks, chemical transfer, salt water and general dewatering applications.
Features durable bronze construction with 3/4 inch NPT input and output ports.
Pump is NOT self-priming and requires flooded suction.
|
363.29 |
|
|
Amt 1640-161-97 Seal 0.63 Subgrp Viton
|
45.90 |
|
|
AMT 4230-97, Coolant Recirculating Pump 1 Phase, 115V, 3/8" NPT Female
3/8" BRONZE COOLANT RECIRCULATING PUMPS
Cast Bronze Construction
No Bottom Bearing!!!
Brass Column and Impeller Shaft
Bronze Self-cleaning Open Impeller
3/8" NPT Discharge Port
Maximum Flow 8 GPM
Maximum Head 10 ft.
Available with 115V AC Single Phase or 230V AC Three Phase Motors,1590 RPM
1/25 HP Totally Enclosed Fan Cooled (TEFC) Motor
Delivers up to 8 GPM and 4 PSI
The AMT Bronze Coolant/Recirculating pump has been manufactured for a wide variety of Industrial/Commercial Coolant and Recirculating applications. The absence of a bottom bearing makes the unit ideal for handling erosive liquids. A 36" 3-conductor power cord is included.
AMT Bronze Coolant/Recirculating pumps are reliable, cost effective and low maintenance. Many are readily available “Off-the-Shelf” for fast, 24 hour shipment. For use with non-flammable liquids compatible with pump component materials.
|
386.98 |
|
|
BURKS 21965-4.97, Wet End Kits for Series G5 1-1/4"
Bronze Fitted Cast Iron Construction.
|
1013.40 |
|
|
Jabsco X1990-97 O'Ring 2.62 X 29.82 Nitrile
|
5.99 |
|
|
Roper Pump N34-97 Seal Kit Buna
|
161.20 |
|
|
Gianneschi SGM45 Brush GM4 7X14 (Cp25/1)
|
44.85 |
|
|
Gianneschi SGM45A Brushes For CP25/1
|
38.21 |
|
|
Guest
Guest makes electrical products that stand up to the punishing marine environment. Every product made, from the rugged battery chargers and switches to a wide array of lights and spotlights, is designed to withstand the rigors of life on the water. Guest engineers each product to exacting performance specifications, including MARINE UL and CUL listings for an extra margin of safety. And as one of the world's leading manufacturer of battery chargers and maintainers, Guest offers a complete line of products to meet practically every application.
|
|
|
10AMP - 12/24V 2 Bank 120V Input On-Board Battery Charger
These onboard chargers have the same housing and mounting dimensions as our traditional Charge Pro Guest chargers with a number of performance enhancements.
Features:
Charge flooded, AGM or Gel batteries
Microprocessor controlled for accurate charging
Universal input 120/230V input for go-anywhere freedom
Intuitive operation
Sense-Send™ technology senses the power needs of each battery and sends correct charge
Isolated outputs
Outputs can be put in series or parallel for higher voltage or current
Completely sealed, epoxy filled
IP68 waterproof
Designed for harsh marine and industrial environments - moisture, salt, shock and vibration tested
Non corroding housing for ultimate reliability
Meet global industry standards including UL*, CE, CSA, ABYC, California efficiency regulations (CEC)
Footprint same as former Charge Pro Guest Chargers
ConnectCharge Plug for easy assembly to inlet (Item #150CCI) with no wiring
* UL certification pending
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
150.11 |
|
|
On-Board Battery Charger 8A / 12V - 2 Bank - 120V Input
Guest On-Board battery chargers have been redesigned from the inside out with the customer in mind. Our newest generation On-Board Marine battery chargers include leading advancements in digital charging technology and waterproof design/construction. Every Guest charger has a dedicated charging, sensing and control per bank. The easy to read graphics indicates the status of each battery bank through the charging process.
Features:
All high frequency, digital charging technology
Fully automatic 5-stage performance charging
Dedicated battery charging, sensing and control per bank
Expanded LED charge status monitor
Wiring and battery fault detection
Auto-maintain energy saver mode
Up to 40 percent lighter
100 percent Waterproof (IP67) and shock resistant for all fresh and saltwater applications
All models are pre-wired for easy installation
For all 12 volt flooded and AGM lead acid batteries
Built-in safety: reverse polarity, over-current, over-voltage, over-temperature and ignition protection. In-line fuses for maximum DC wire protection.
2 year warranty
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
107.62 |
|
|
On-Board Battery Charger 5A / 12V - 1 Bank - 120V Input
Guest On-Board battery chargers have been redesigned from the inside out with the customer in mind. Our newest generation On-Board Marine battery chargers include leading advancements in digital charging technology and waterproof design/construction. Every Guest charger has a dedicated charging, sensing and control per bank. The easy to read graphics indicates the status of each battery bank through the charging process.
Features:
All high frequency, digital charging technology
Fully automatic 5-stage performance charging
Dedicated battery charging, sensing and control per bank
Expanded LED charge status monitor
Wiring and battery fault detection
Auto-maintain energy saver mode
Up to 40 percent lighter
100 percent Waterproof (IP67) and shock resistant for all fresh and saltwater applications
All models are pre-wired for easy installation
For all 12 volt flooded and AGM lead acid batteries
Built-in safety: reverse polarity, over-current, over-voltage, over-temperature and ignition protection. In-line fuses for maximum DC wire protection.
2 year warranty
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
87.00 |
|
|
On-Board Battery Charger 10A / 12V - 1 Bank - 120V Input
Guest On-Board battery chargers have been redesigned from the inside out with the customer in mind. Our newest generation On-Board Marine battery chargers include leading advancements in digital charging technology and waterproof design/construction. Every Guest charger has a dedicated charging, sensing and control per bank. The easy to read graphics indicates the status of each battery bank through the charging process.
Features:
All high frequency, digital charging technology
Fully automatic 5-stage performance charging
Dedicated battery charging, sensing and control per bank
Expanded LED charge status monitor
Wiring and battery fault detection
Auto-maintain energy saver mode
Up to 40 percent lighter
100 percent Waterproof (IP67) and shock resistant for all fresh and saltwater applications
All models are pre-wired for easy installation
For all 12 volt flooded and AGM lead acid batteries
Built-in safety: reverse polarity, over-current, over-voltage, over-temperature and ignition protection. In-line fuses for maximum DC wire protection.
2 year warranty
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
127.20 |
|
|
On-Board Battery Charger 10A / 12V - 2 Bank - 120V Input
Guest On-Board battery chargers have been redesigned from the inside out with the customer in mind. Our newest generation On-Board Marine battery chargers include leading advancements in digital charging technology and waterproof design/construction. Every Guest charger has a dedicated charging, sensing and control per bank. The easy to read graphics indicates the status of each battery bank through the charging process.
Features:
All high frequency, digital charging technology
Fully automatic 5-stage performance charging
Dedicated battery charging, sensing and control per bank
Expanded LED charge status monitor
Wiring and battery fault detection
Auto-maintain energy saver mode
Up to 40 percent lighter
100 percent Waterproof (IP67) and shock resistant for all fresh and saltwater applications
All models are pre-wired for easy installation
For all 12 volt flooded and AGM lead acid batteries
Built-in safety: reverse polarity, over-current, over-voltage, over-temperature and ignition protection. In-line fuses for maximum DC wire protection.
2 year warranty
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
136.60 |
|