Flotec FP3212 3-Wire 4 Inch Submersible Well Pump, 230 Volts 1/2 HP, 10 GPM 4" Submersible Pumps are the most economical, energy-efficient pumps for 4" wells or larger. They provide the optimum amount of water and pressure for general home and farm use.   KEY FEATURES For 4" inside diameter or larger wells Pumps from depths of 150ft Floating Stack Design for sand resistance and reduced sand locking Corrosion-resistant stainless steel pump and motor housing   3 year limited warranty HORSEPOWER:  1/2 PERFORMANCE SERIES:  10 GPM VOLTAGE:  230v, 60 Hz NUMBER OF WIRES:  3 plus ground BODY CONSTRUCTION:  Stainless steel MAXIMUM CAPACITY:  14 GPM OPERATING RANGE:  20' to 150' MAXIMUM DEPTH-TO-WATER:  150' MAX PSI:  105 psi PUMP DIAMETER:  3.78" DISCHARGE PIPE SIZE:  1-1/4" NPT RECOMMENDED BREAKER:  10 amp

Flotec FP2212 2-Wire 4 Inch Submersible Well Pump, 230 Volts 1/2 HP 4" Submersible Pumps are the most economical, energy-efficient pumps for 4" wells or larger. They provide the optimum amount of water and pressure for general home and farm use.   KEY FEATURES For 4" inside diameter or larger wells Pumps from depths of 150ft Floating Stack Design for sand resistance and reduced sand locking Corrosion-resistant stainless steel pump and motor housing   3 year limited warranty HORSEPOWER:  1/2 PERFORMANCE SERIES:  10 GPM VOLTAGE:  230v, 60 Hz NUMBER OF WIRES:  2 plus ground BODY CONSTRUCTION:  Stainless Steel MAXIMUM CAPACITY:  13.6 GPM OPERATING RANGE:  20' to 150' MAXIMUM DEPTH-TO-WATER:  150' MAX PSI:  105 psi PUMP DIAMETER:  3.78" DISCHARGE PIPE SIZE:  1-1/4" NPT RECOMMENDED BREAKER:  10 amp

Flotec 3-Wire 4 Inch Submersible Well Pump, 230 Volts 1.5 HP, 10 GPM 4" Submersible Pumps are the most economical, energy-efficient pumps for 4" wells or larger. They provide the optimum amount of water and pressure for general home and farm use. KEY FEATURES For 4" inside diameter or larger wells Pumps from depths of 300ft Floating Stack Design for sand resistance and reduced sand locking Corrosion-resistant stainless steel pump and motor housing WARRANTY 3 year warranty HORSEPOWER:  1-1/2 PERFORMANCE SERIES:  10 GPM VOLTAGE:  230v, 60 Hz NUMBER OF WIRES:  3 plus ground BODY CONSTRUCTION:  Stainless Steel MAXIMUM CAPACITY:  16 GPM OPERATION RANGE:  40' to 300' MAXIMUM DEPTH-TO-WATER:  300' MAX PSI:  170 psi PUMP DIAMETER:  3.78"   DISCHARGE PIPE SIZE:  1-1/4"

Flotec FP2122 Submersible Well Pump 4" Flotec Submersible Well Pump, for 5" or Larger Wells, Stainless Steel Pump and Motor Housing, 7GPM Series, 2 Wire, 3/4HP 230V, 1-1/4”NPT Port, Water Filled Submersible Motor, Built-in Check Valve, No Control Box Required

Flotec FP2112 Submersible Well Pump 4" Flotec  Submersible Well Pump, for 5" or Larger Wells, Stainless Steel Pump and Motor Housing, 7GPM Series, 2 Wire, 1/2HP 230V, 1-1/4”NPT Port, Water Filled Submersible Motor, Built-in Check Valve, No Control Box Required

Iwaki WMD-30RLZT, 3/4 inch MPT in/outlet 270gph 120v Iwaki WMD 30RLZT Water Pump American motor high pressure water rated pump 3/4 inch MPT inlet and outlet. 1/16 HP Motor output. 3150 RPM motor speed. 120 volts 1.00 amps. Max flow 4.5 GPM. 270 GPH Max head 36.1 ft. Max system pressure 24.20 psi.   WMD pumps have American Made Motors MD pumps have Japanese Made Motors RLT pumps are for pressure applications RZT pumps are for very high pressure applications RLXT pumps are for circulation and wet or dry return

Iwaki WMD-20RLZT, 3/4 inch MPT in/outlet 174gph 120v Iwaki WMD 20RLZT Water Pump   American motor high pressure rated water pump. 3/4 inch MPT inlet and outlet. 1/38 HP Motor output. 3100 RPM motor speed. 120 volts 0.53 amps Max flow 2.9 GPM. 174 GPH Max head 22.6 ft. Max system pressure 14.22 psi.   WMD pumps have American Made Motors MD pumps have Japanese Made Motors RLT pumps are for pressure applications RZT pumps are for very high pressure applications RLXT pumps are for circulation and wet or dry return

Flotec FP4105 Cast Iron Jet Pump 1/2 HP New cast iron shallow well jet pump is ideal for wells with pumping levels of 25' or less. Self-priming after the pump housing is initially filled with water. KEY FEATURES Reliable performance at 25' depth to water or less Maximum pressures of 63 PSI and maximum pumping capacities to 5.1 GPM Pump housing is constructed of heavy-duty cast iron and is ready to install 115 volt 1/2 HP Fan cooled, completely enclosed motor 1" Suction Port and 1" Discharge Port WARRANTY 1 year limited warranty BODY CONSTRUCTION:  Cast Iron HORSEPOWER:  1/2 MAXIMUM CAPACITY:  5.6 GPM FLOW at 10' LIFT and 40 PSI:  4.5 GPM MAX LIFT:  25' MAXIMUM PRESSURE:  63 PSI PRESSURE SWITCH SETTING:  30/50 SUCTION PIPE SIZE:  1" NPT DISCHARGE PIPE SIZE:  1" NPT AMP DRAW (full load):  7.2 amps VOLTAGE:  115v, 60 Hz RECOMMENDED BREAKER:  15 amp   MAXIMUM WATER TEMPERATURE:  140 F (60 C)

BURKS 24CT6M, Turbine Pump 115/230v 1"Ports Turbine Pump and Motor unit. Bronze Fitted Cast Iron Construction. Close Coupled to a 1/4 Horsepower, 1750 RPM, 115/230 Volts, 1 Phase Motor. Ports are 1 Inches NPT Inlet, 1 Inches NPT Outlet.

Flotec FP4312 Thermoplastic Convertible Jet Pump 1/2 HP Corrosion resistant convertible jet pumps are constructed of rugged fiberglass-reinforced thermoplastic, and assure years of dependable service. KEY FEATURES Superior performance at depths to water of 100' or less Fiberglass-reinforced thermoplastic pump housing for the highest corrosion resistance Ready-to-install dual voltage motor preset to 115v - see manual for 230 volt conversion WARRANTY 1 year limited warranty BODY CONSTRUCTION:  Thermoplastic HORSEPOWER:  1/2 MAXIMUM CAPACITY:  9 GPM (shallow well setup) FLOW AT 10' LIFT and 40 PSI:  7.8 GPM (shallow well setup) MAX LIFT:  25' w/ shallow well jet kit / 70' w/ deep well jet kit MAX PSI:  62 psi (shallow well setup) PRESSURE SWITCH SETTING:  30/50 SUCTION PIPE SIZE:  1-1/4" MINIMUM SUCTION PIPE SIZE:  1-1/4" DRIVE PIPE SIZE:  1" DISCHARGE PIPE SIZE:  1" MINIMUM DISCHARGE PIPE SIZE:  3/4" AMP DRAW:  9.9 Amps on 115V / 4.95 Amps on 230V VOLTAGE:  115v/230v, 60 Hz (factory preset to 115v) RECOMMENDED BREAKER:  15 amp   MAXIMUM WATER TEMPERATURE:  140 F (60 C)

Flotec FPZT7350 1/2 HP Zinc Body Submersible High Output Sump Pump, Vertical Switch A ½ HP version of our highly engineered sump line – this pump moves up to 6,000 gallons per hour! The vertical switch allows this pump to fit in a sump basin as small as 10” wide.   FEATURES Corrosion Resistant Zinc Construction - Dissipates heat quickly and extends motor life Uni-Body Motor Housing - Eliminates leak points and maximizes pump life Stainless Steel Fasteners and Hardware - Superior quality Quadra SealTM Technology - Provides superior motor protection over single seal designs Smooth Flow HydraulicsTM - Deliver high performance for demanding applications Vertical Float Switch - Operates in 10” basins or larger   3 year limited warranty BODY CONSTRUCTION:  Zinc HORSEPOWER:  1/2 MAXIMUM CAPACITY:  6,000 GPH FLOW at 10' LIFT:  4,140 GPH SWITCH TYPE:  Vertical Float FLOAT SWITCH 'ON' LEVEL:  7-1/2" FLOAT SWITCH 'OFF' LEVEL:  3" MINIMUM SUMP DIAMETER:  10" DISCHARGE PIPE SIZE:  1 1/2” NPT MAXIMUM SOLIDS HANDLING SIZE:  3/8" CORD LENGTH:  8' VOLTAGE:  115 VAC, 60 Hz

Flotec FP4112-08 Cast Iron Shallow Well Jet Pump 1/2 HP Cast iron shallow well jet pumps provide superior performance and high capacities with more pressure for shallow wells 25' or less.   KEY FEATURES Superior performance at depths to water of 25' or less Rugged, heavy-duty cast iron pump housing Ready-to-install dual voltage (115v/230v) motor 1-1/4" NPT suction and 1" NPT discharge pipe sizes   WARRANTY 1 year limited warranty   BODY CONSTRUCTION:  Cast Iron HORSEPOWER:  1/2 MAXIMUM CAPACITY:  8.8 GPM FLOW AT 10' LIFT and 40 PSI:  7.8 GPM MAX PSI:  56 psi PRESSURE SWITCH SETTING:  30/50 SUCTION PIPE SIZE:  1-1/4" NPT MINIMUM SUCTION PIPE SIZE:  1" NPT DISCHARGE PIPE SIZE:  1" MINIMUM DISCHARGE PIPE SIZE:  3/4" AMP DRAW:  9.4 amps VOLTAGE:  115v/230v (preset to 115v), 60 Hz RECOMMENDED BREAKER:  15 amp LIQUID TEMP RANGE:  32°F-140 °F (0°C-60 °C) JET KIT:  included ACCESSORIES INCLUDED:  none

Little Giant Condensate Pump 554425 Little Giant VCMA-20ULS Condensate Pump Motor 115 Volts 1/30 hp high performance motor, ABS tank, motor cover, and volute, 1/2 gallon tank capacity Stainless steel shaft, Removable 3/8" (9.5 mm) barbed check valve, 3 inlet drain holes, Thermal overload protection   554425 For removal of condensate from an air conditioner, suitable for high efficiency, gas furnace condensation, and condensing boilers

Little Giant Condensate Pump 554435 Little Giant VCMA-20ULST Condensate Pump Motor 115 Volts 1/30 hp high performance motor ABS tank, motor cover, and volute, 1/2 gallon tank capacity, Stainless steel shaft, Removable 3/8" (9.5 mm) barbed check valve, 3 inlet drain holes, Thermal overload protection   554435 For removal of condensate from an air conditioner, suitable for high efficiency, gas furnace condensation, and condensing boilers

Flotec FP4012-10 Thermoplastic Shallow Well Jet Pump 1/2 HP This new revision provides good pressure pumping from wells where the depth-to-water is 25' or less. KEY FEATURES Perfect for shallow wells (depth-to-water less than 25') Thermoplastic construction for higher corrosion resistance 1-1/4" Suction / 1" Discharge Comes with pre-wired 30/50 pressure switch WARRANTY 1 year limited warranty BODY CONSTRUCTION:  Thermoplastic HORSEPOWER:  1/2 MAXIMUM CAPACITY:  8 GPM FLOW at 10' LIFT and 40 PSI:  6.4 GPM MAX LIFT:  25' MAX PRESSURE:  77 psi PRESSURE SWITCH SETTING:  30/50 SUCTION PIPE SIZE:  1-1/4" NPT DISCHARGE PIPE SIZE:  1" NPT AMP DRAW (full load):  9.4 amps VOLTAGE:  115v/230v, 60 Hz (factory preset to 115v) RECOMMENDED BREAKER:  15 amp   MAXIMUM WATER TEMPERATURE:  140 °F (60 °C)