201 Remote Control with 40' Cable This remote control has 3 modes: Standby, Tiller & Pilot

101 Remote Control This remote control has standyby power, power steer, pilot and nav modes plus dodge and U-turn functions.

ComNavPassive GPS antenna w/8M cable & TNC connector for X2, X3 and X5 AIS'

C-Series Digital Remote with 50' Cable Meter, digital volt, C-Series remote with 50' cable Used with C35/40/60 Charge Controllers WARNING: This product can expose you to chemicals including Diisononyl Phthalate (DINP) which is known to the State of California to cause cancer, and Di-isodecyl Phthalate (DIDP) which is known to the State of California to cause reproductive harm. For more information go to P65Warnings.ca.gov.

TS203 Full Follow-Up Remote Lever for SP36 & SP38 Pilot System with 40' Cable SI-TEX Full Follow-Up Remote Lever specifically for the SP36 and SP38 Pilot System.  Comes with a 40' cable.

Digital Media Wired Remote with Extension Cable The Roswell Digital Media Wired Remote delivers convenient control of the media receiver in a secondary location on a boat or vehicle. Featuring a compact design and an IP66 rating for excellent water resistance, mount it anywhere you want to DJ from a distance. Features: IP66 rated for excellent water resistance (when properly installed)     Backlit LCD Display Allows source switching and zone control     Single-wire hookup for easy installation Ideal for mounting within any secondary location where stereo control is desired Inside this Box: (1) wired remote  (1) 20 ft. remote extension cable  Mounting screws Specifications: Width: 4 in. | 10.1cm Height: 3 in. | 7.29cm

Full Follow-Up Remote with 6M Cable SI-TEX Remote with 6M Cable. Features: Full Follow-Up Comes with 6M Cable

Non Follow-Up Remote with 6M Cable SI-TEX Remote with 6M Cable. Features: Non Follow-Up Comes with 6M Cable

SVS Series Replacement GPS Antenna w/10M Cable Replacement External GPS Antenna for SVS series w/10 Meter cable

Tuthill CCI102017 Pump W/Vtn Seal 56C Cast Iron Rotary Gear Pump Pump End Only, 20 GPM CC Series Pump Cast Iron Construction Nema frame size is 56C Inlet Port is 1-1/2 inch NPT Discharge Port is 1-1/2 inch NPT  

CT2 Drive Box ComNav CT2 Drive Box are specifically designed to connect Comnav 1001, 1101, 1201, and 2001 autopilots to steering systems using reversing DC Motor Pump sets, Linear actuators or DC Motor Mechanical Drive Units. The CT2 Drive Box features dynamic braking, current limiting and thermal protection of the MOFSET driving transistors while allowing full power acceleration when needed. CT2 Drive Box can be used with 12, 24 and 32VDC battery systems. Highlights of the CT2 Drive box include: Solid state circuitry Anodized aluminum housing (watertight if installed correctly) Current limiting Thermal protection Dynamic braking Rated 40 Ampere

Fluxgate Compass Specifically designed for ComNav Autopilots, the ComNav Fluxgate Compass senses the earth's magnetic field directly. A heeling adjust control is provided to reduce or eliminate the effect of the vessel's vertical field. Features:: Microprocessor controlled Temperature range -15 degrees Celsius to +85 degrees Celsius Power supplied by ComNav autopilot Watertight high impact case Accuracy +/- 1.0 degrees (after compensation) DC sine and cosine output signals Compact size 40' cable and mounting brackets supplied

Stand Alone Rudder Angle Indicator System Complete single station RAI system typically used on vessels that do not have a ComNav autopilot or, in cases where a separate RAI system is required (such as Hydraulic Full Follow-up steering systems). The Stand Alone System consists of three components: ComNav Rudder Follower w/50' cable and linkage kit RAI Distribution Box w/special circuitry ComNav 3" Rudder Angle Indicator

Reactor™ 40 Hydraulic Corepack with SmartPump v2 & GHC™ 50 Autopilot Instrument Pack Every Captain Needs a Co-Pilot. Designed for powerboats, this Reactor 40 hydraulic corepack with SmartPump v2 and GHC™ 50 display gives you the extra hand you need, so you can explore paradise worry-free.  Features: This Reactor 40 corepack is the perfect companion for your hydraulically steered system. With its advanced solid-state 9-axis AHRS, you can mount Reactor 40 nearly anywhere, in any orientation.  It even reduces power consumption, minimizes heading error, and more. Even when you’re pitching or rolling, this autopilot reacts to sea conditions to keep you on course. You just want to get on the water, so we made calibration fast and easy.  That’s the power of simplicity. Control your autopilot from anywhere on your boat by using your compatible Garmin devices, including the Reactor autopilot remote, select quatix® marine smartwatches, and more (requires a compatible Garmin chartplotter or GHC 50 autopilot instrument.) The SmartPump v2 is a one-size-fits-most solution that provides optimal control and confidence on the water. Plus, gain better thermal performance, higher reliability, and lower power consumption. Gain more freedom when maneuvering your boat.  This corepack allows for optional Shadow Drive technology to automatically disengage the autopilot when you turn the wheel. Want more?  The optional GHC™ 50 autopilot instrument enhances your autopilot experience. When connected to your compatible Garmin chartplotter, all Reactor 40 corepacks offer powerboat and sailing features, including heading hold and step turns — plus wind hold and tack/jibe when paired with a wind sensor (sold separately.)  Technical Specifications - SmartPump v2: Dimensions (H x W x D) - 7 3/4" x 7 1/2" x 9 5/8" (197 mm x 190 mm x 244 mm) Weight - 16.5 lbs (7.5 kg) Temperature range - From 5°F to 131°F (from -15°C to 55°C) Material - Electronics Control Unit (ECU) - fully gasketed, aluminum alloy.  Bracket - carbon steel.  Manifold - aluminum alloy.  Motor - aluminum alloy Power cable length - 9 ft (2.7 m) Power input - 11.5-30 Vdc Fuse - 40 A, blade-type Main power usage (standby) - less than 1 A. Main power usage (engaged) - 5-10 A and peak - 34 A Flow rate - Configurable from 0 to 2.4 L per minute Compatible with steering cylinder sizes from 4-24 cu in.  7-second lock to lock up to 17 cu in Technical Specifications - CCU: Dimensions: 3 19/32" diameter (91.4 mm) Weight: 5.6 oz (159 g) Temperature range: From 5°F to 131°F (from -15°C to 55°C) Case material: Fully gasketed, high-impact plastic, waterproof to IEC 529 IPX7 standards CCU cable length: 9.5' (3 m) NMEA 2000 power input: 9-16 V NMEA 2000 LEN: 3 (150 mA) Technical Specifications - Buzzer/Alarm: Dimensions (L × Diameter) - 29/32" × 1.0" (23 mm × 25 mm) Weight - 2.4 oz (68 g) Temperature range - from 5°F to 131°F (from -15°C to 55°C) Cable length - 10' (3.0 m) Technical Specifications - Reactor 40: Unit dimensions (W x H x D) - 4.3" x 4.4" x 1.9" (10.9 x 11.2 x 4.8 cm) Display resolution (W x H) - 320 x 240 pixels Display Type - QVGA color LCD display NMEA output - NMEA 2000 Supply voltage - 10 to 20V Operating temperature - -15° C to 70 C° (5° F to 158° F) Technical Specifications - GHC™ 50: Dimensions (H x W x D) - 5.5” x 4.1” x 2.0” (14.0 x 10.5 x 5.1 cm)  Display Type - 800 x 480 WVGA Display Size - 5" (12.7 cm) Touch Display - Yes Knob Control - With GRID 10/20 Remote Control via ANT+® Connectivity - Yes Wi-Fi Connectivity - Yes NMEA 2000 Networking - Yes Ethernet - Yes What's in the Box? GHC™ 50 Marine Autopilot Display SmartPump v2 Reactor 40 CCU (Course Computer Unit) ECU (Electronic Control Unit) power cable Interconnect cable Shadow Drive Buzzer NMEA 2000® drop cables (2 meters) NMEA 2000 power cable NMEA 2000 T-connectors Male and female terminators Documentation *Sold as an Individual 

SC70 Satellite Compass w/o Cable The SC70 is the latest satellite compass built on FURUNO’s commercial-grade technology platform. These satellite compasses prove their value by increasing the accuracy of other devices, such as Radar, ARPA, Scanning Sonar, Current Indicator, Chart Plotter, ECDIS and Autopilots. They provide a highly accurate heading input to these other technologies by utilizing the very latest GNSS (Global Navigation Satellite System). This satellite system is comprised of GPS, Galileo and GLONASS to ensure the highest precision and a continuous coverage. The SC70 provides a variety of data, including GPS Positioning, SOG (Speed Over Ground), COG (Course Over Ground), ROT (Rate Of Turn) and 3-axis speed (bow, stern and longitudinal). All of these data assist with critical maneuvers, such as berthing. The compasses is maintenance free - a great asset for any vessel. Consists Of: SC701 - Junction box for SC70/SC130 SC702 - Display unit for SC70/SC130 SC703 - ANT 2GPS/ANG/ACCEL/MGNT SNSR Note: The SC70 and SC130 are sold without an antenna cable. Standard Features: Provides highly accurate heading data of 0.4° for autopilot, Radar, ARPA, Scanning Sonar, Current Indicator, Chart Plotter, ECDIS and Autopilots Ideal for small to medium boats requiring highly accurate heading Utilizes GNSS such as GPS, Galileo and GLONASS for high Precision SBAS compatible (EGNOS,WAAS,MSAS) Provide precise data for SOG, COG, ROT and L/L Eliminating the problem of not having enough satellites at hand by using multiple types of satellites Speed on 3 axis (bow, stern and longitudinal) for safe navigating and berthing IMO Type-approved as THD, GPS and ROTI. Complying with the IEC, ISO requirements Easily integrated into the existing shipboard network via Ethernet Rapid follow-up rate 40°/s (twice the IMO high speed craft requirement, 20°/s) Maintenance free and no recurring cost as there are no mechanical parts Super short starting time - 90 seconds Once the power is on, it takes about 90 seconds to start (the starting time will slightly differ depending on the equipment location) Easy to retrofit by using existing antenna cabling for SC-50/55/60/110/120. (The LAN_CNV option kit is necessary) Precision pitch/roll data in Analog and Digital formats for vessel stabilization, Sonar, etc. This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.