|
Flojet 03501-503A Agricultural Sprayer Pump
Max. Flow: 2.0 gpm
Max. Pressure - Pumps: 60 psi
Voltage - Pumps: 12V DC
Inlet/Outlet: 3/8 in FNPT
|
182.20 |
|
|
Flojet LF112421F Pump 12V On-Demand 40Psi
Flojet Industrial LF Pumps are designed for a wide range of applications and are constructed from a selection of materials suitable for handling a broad range of chemicals. The LF series of diaphragm pumps are selfpriming and can be run dry without harm. They are intended for intermittent duty cycles but can be run continuously for short periods of time. Typical pump uses are liquid transfer, spraying, circulation, filtration and dispensing.
Duplex Diaphragm Pump with Fin Cooled Motor
Compact pump design
Sealed pressure switch automatically starts and stops pump when discharge valve is opened and closed
Selfpriming and can operate dry without damage
Sealed motor or with protective metal cooling finned cover
Integral 5 amp inline fuse with cover
|
101.30 |
|
|
Flojet 04105-503A Pump 24V 3.3Gpm
Flojet- Diaphragm Pump Quad 24 Volt DC, 3/4” Hose Barb Snap-In Ports, 3.3GPM, Polypropylene, Buna Valves, Geolast Diaphragm, no Switch, Includes Strainer, U.S.C.G. Approved
|
247.78 |
|
|
Flojet R3B21-503A Mpu 24V S/V 2.5C Nsw Bp50
Flojet- Diaphragm Pump Triplex, Road Roller Series, 24V Continuous Duty Motor, 1.25GPM at 30psi, 50psi Bypass, No Pressure Switch, Viton Valves, Santoprene Diaphragm, 1/2" Hose Barb Snap-In Port Fittings, Includes Strainer
|
234.73 |
|
|
Flojet D71X000A Mpu 12V B/B 3C N/Sw Bp60
Flojet Duplex II Diaphragm Pump, with Polypropylene Body Construction, Buna Diaphragm, Buna Check Valve, 50 PSI Pressure Bypass. Motor is 12 Volt DC. Inlet Port is 3/8 inch NPT Female, Discharge Port is 3/8 inch NPT Female.
The Flojet D71X000A Duplex II Pump is designed for a wide range of applications and is constructed from a selection of materials suitable for handling a broad range of chemicals. Typical pump uses are liquid transfer, spraying, cooling, circulation, filtration and dispensing. This pump is generally used for general Agricultural applications. If pumping a liquid other than water the pump should be flushed with water if applicable after each use.
|
203.44 |
|
|
Flojet 20467-007 Kit Check Valve Sto
Flojet 20467007 Santoprene Check Valve Kit For N5100 Series Pump
Replacement Check Valve
The Flojet 20467007 Repair Kit allows you to replace a cracked or worn check valve on a N5100 Series pump. The check valve in this kit is made with Santoprene material.
Genuine Flojet replacement parts
Santoprene material check valves
Use with N5100 Series Industrial Air Driven Pumps
|
34.40 |
|
|
Flojet 02090-118 Pressure Switch 40Psi 4300 Series Pumps
Flojet 02090-118 is a pressure switch replacement kit for Flojet 4300 Series pumps. It is a 40 psi direct mount for the Series 4305 pump.
Fits the following pump models: 4305-143, 4305-144, 4305-343, 4305-443, 4325-043, 4325-143.
|
61.75 |
|
|
Flojet D2131I5011A Diaphragm Pump 12V 1.6Gpm
Replacement For : Flojet 02135-561
The Duplex II series of pumps incorporate the best technology features developed by Flojet. Everything from the back flow preventer, check valves, bearings and diaphragm assembly to the motor, have been designed to make this truly the most advanced and reliable diaphragm pump available. Higher efficiency of the pump is evident in the longer life of the motor pump unit. The new diaphragm design combined with the new valves makes the pump capable of pulling higher dry vacuum. Duplex II is available in various performance ranges, voltages and with a choice of elastomers, making it easily adaptable to a diverse range of applications.
Features :
Self priming up to 8 feet (2.4 m).
Can run dry without damage.
Chemical resistant material.
Internal bypass standard.
Built-in back flow preventer.
Heavy duty ball bearing drive system.
UL, CSA and CE models available.
Specifications:
Diaphragm Pump Duplex II 12V
3/8" FNPT Ports
1.6GPM
60PSI Switch
Polypropylene
EPDM Valves
Santoprene Diaphragm
|
207.90 |
|
|
Flojet D3635B7011A 115V Pmp B/B 3C Sw100
Flojet D3635B7011A Duplex II Diaphragm Pump, 2.2GPM, 90PSI, 115V
Flojet Self-Priming Diaphragm Pump
Flojet D3635B7011A Duplex II diaphragm pump provides excellent liquid handling of waterlike and other liquids up to 250 cP. These pumps are the perfect fit for many car wash fluid needs. 3/8" FNPT ports make line attachment a breeze. Polypropylene pump head provides extended pump life. Pump is self-priming up to 8 feet.
Features:
115V AC electric motor
Buna seals and check valve.
Max Flow: 2.2 GPM
Max Pressure: 90 PSI
Inlet Port: 3/8" NPT female
Outlet Port: 3/8" NPT female
|
278.33 |
|
|
Flojet 04524-500A Pump 115V S/E 4.5Gpm 45Psi
Flojet- Diaphragm Pump Quad, Water Pressure System, VSD, 115V, Automatic Variable Speed for Constant 45PSI Pressure at Up To 5GPM, Santoprene Diaphragm, EPDM Valves, No Accumulator Tank Required, Includes Power Cord and 10/13mm (1/2") Hose Barb Snap-In Port Fittings
Features:
4524 Series AC Quad Pump with VSD Module The AC Variable Speed Drive constant pressure pump system matches motor speed to system demand. As more liquid is needed, the motor responds to increase flow. Conversely, as the demand lessens, the motor slows to a "super quiet" speed, always retaining a constant system pressure. The result is exceptionally stable flow and reduced apm draw. The Flojet AC VSD sensorcontrolled pumps provide stable, constantpressure operation on any AC application. Operation from no flow to maximum flow is proportionally controlled, eliminating unwanted pump switch cycling and the need for an accumulator tank. Model No. 4524 Series AC Quad VSD • Maintains steady fluid pressure in response to variable flow demand • No pressure switch • Conserves energy, low amp draw • Quiet running under normal use • Automatically adjusts motor speed to maintain pressure • Improves overall system performance • Eliminates bulky accumulator tank for limited SPACErequirements
|
481.51 |
|
|
Flojet 20467-006 Kit Check Valve Viton
Flojet Viton Check Valve Assembly Kit For N5100 Pumps
Use this check valve chamber kit to repair your Flojet N1500 series pump. Check valves allow fluids to flow in one direction while preventing back flow, or reverse flow, from occurring.
Viton
|
34.36 |
|
|
Flojet D3732E1311A Duplex Pump 230V 60Psi Epdm
The Duplex II series of pumps incorporate the best technology features developed by Flojet. Everything from the back flow preventer, check valves, bearings and diaphragm assembly to the motor, have been designed to make this truly the most advanced and reliable diaphragm pump available. Higher efficiency of the pump is evident in the longer life of the motor pump unit.
Features :
Self priming up to 8 feet (2.4 m).
Can run dry without damage.
Chemical resistant material.
Internal bypass standard.
Built-in back flow preventer.
Heavy duty ball bearing drive system.
UL, CSA and CE models available.
Specifications:
Diaphragm Pump Duplex II 230V
3/8" FNPT Ports
1.6 GPM
No Switch
Bypass 50psi
Polypropylene
EPDM Valves
EPDM Diaphragm
|
240.33 |
|
|
Flojet 04300-525A 115V 3.3Gpm S/V Sw45
Flojet 04300525A Electric Quad Series Diaphragm Pump With 6 Ft. Cord - 5 GPM, 35 PSI, 115VAC
Polypropylene Pump & Motor Assembly
The Flojet 04300525A pump is part of the Flojet 4300 Quad Series. This versatile pump cam be used for car wash services, water treatment, filtering, and more. It is made with chemical resistant materials including a Polypropylene body, a Viton check valve, and a Santoprene diaphragm.
The Flojet 04300525A pump includes 3/4" snap-in hose barb style ports and a 6' power cord. It has a 35 PSI maximum pressure rating and a flow rate of 5 GPM. Quiet, smooth, and safe operation!
Specifications and Benefits:
5 GPM
35 PSI
115 volt AC
3/4" hose barb inlet
3/4" hose barb outlet
Polypropylene housing
Viton check valve
Santoprene diaphragm
6' power cord
Snap-in ports for easy installation
130° Fahrenheit maximum fluid temperature
Built-in pressure switch automatically starts and stops
Can run dry without damage
Excellent self-priming capability (up to 8 feet vertical)
Powerful magnet motor with low current draw
4 piston design delivers high flow rates
Handles water-like and viscous liquids up to 250 cP
CE Certified
|
327.51 |
|
|
Flojet 04300-529A Mpu 115V S/V 3C Sw40
Flojet 04300529A Electric Quad Series Diaphragm Pump With 6 Ft. Cord - 3.5 GPM, 35 PSI, 115VAC
Polypropylene Pump & Motor Assembly
The Flojet 04300529A pump is part of the Flojet 4300 Quad Series. This versatile pump cam be used for low-pressure car wash services, water treatment, filtering, and more. It is made with chemical resistant materials including a Polypropylene body, a Viton check valve, and a Santoprene diaphragm.
The Flojet 04300529A pump includes 1/2" snap-in hose barb style ports and a 6' power cord. It has a 35 PSI maximum pressure rating and a flow rate of 3.5 GPM. Quiet, smooth, and safe operation!
Specifications and Benefits:
3.5 GPM
35 PSI
115 volt AC
1.8A maximum amps
Continuous duty induction motor
1/2" hose barb inlet
1/2" hose barb outlet
Polypropylene housing
Viton check valve
Santoprene diaphragm
6' power cord
Snap-in ports for easy installation
130° Fahrenheit maximum fluid temperature
Can run dry without damage
Excellent self-priming capability (up to 8 feet vertical)
Powerful magnet motor with low current draw
4 piston design delivers high flow rates
Handles water-like and viscous liquids up to 250 cP
CE Certified
|
685.71 |
|
|
Flojet 21050-032 Pump Head for Flojet 2100-032
|
157.40 |
|