|
Air-Dryr™ Mildew Fighter
Say Goodbye to Mold, Mildew and Moisture
1458 Air-Dryr 1000. Handles up to 1000 cubic feet of living space. Draws only 1.1 amps,130 watts. Circular unit measures 13.5" in diameter (34 cm) and 4.25" high (11 cm). EU model handles up to 28 cubic meters of living space.
Air-Dryrª is an inexpensive and effective way to fight moisture problems, cold drafts, and corrosion. Designed to operate anywhere, 24 hours a day. Place Air-Dryr on the floor in any damp, enclosed space and plug into a 110/120 volt outlet. The damp air is heated to the point moisture is held in suspension (above dew point), then released through the top vents of the device. As warmed air rises, cooler damp air is drawn in, where it too is heated. Air-Dryr costs no more to operate than the burning of a light bulb. A thermal cutoff turns the unit off should air flow be impeded.
Key Features of all Air-Dryr Units:
Attractive, neutral beige housing made of polycarbonate for strength and durability
Slim and stable
Can be placed out of the way in confined spaces
Handle a high volume of air
Designed to be left on 24 hours a day
Safe to the touch
Low operating cost
Trouble free
no switch, fan, or thermostat; uses natural convection to circulate the air
Silent operation
Safe for marine use
no components which cause sparking
UL listed
Use at Home or Office
Basements
Closets
Under Desks
Storage Units
Tack Rooms
Pump Rooms
Gun Cabinets
Pianos
Use in RVs
Motor Homes
Trailers Cars Airplanes
Use in Boats
Cabins
Bilges
Engine Rooms
V-Berths
|
60.76 |
|
|
Stor-Dry 9406 110V Warm Air Circulator & Dehumidifier - 75W
Low wattage warm air circulator. Prevents mold and mildew. Great for boat storage.
The Stor-Dry low wattage warm air circulator is the "must-have" product for the winterization season. The model 9406 Stor-Dry combats mold, mildew, and musty odors in any boat that is closed up or winterized. This dual-action air dryer uses a low-wattage heating element and internal fan to both heat and circulates the air. The heat and circulation prevent stale air pockets which in turn prevent mold or mildew from forming on the interior surface of the boat.
Features:
Dual-action of fan and heating element
Low power consumption of 90 watts
Raises the ambient temperature above the dew point
Corrosion-resistant aluminum
Rugged construction
Made in Canada
2-year warranty
Benefits:
Superior performance overheating element only products
No maintenance required
Effective in areas up to 1000 cubic feet
Controls mold and mildew
Ready to use out of the box
Odor free boats
Years of trouble free use
|
104.29 |
|
|
Air-Dryr™ Mildew Fighter
Say Goodbye to Mold, Mildew and Moisture
1459 Air-Dryr 500. Handles up to 500 cubic feet of living space. Draws only 0.6 amps, 70 watts. Rectangular unit measures 14 x 5 x 4.5" (36 x 13 x 11 cm). EU model handles up to 14 cubic meters of living space.
Air-Dryrª is an inexpensive and effective way to fight moisture problems, cold drafts, and corrosion. Designed to operate anywhere, 24 hours a day. Place Air-Dryr on the floor in any damp, enclosed space and plug into a 110/120 volt outlet. The damp air is heated to the point moisture is held in suspension (above dew point), then released through the top vents of the device. As warmed air rises, cooler damp air is drawn in, where it too is heated. Air-Dryr costs no more to operate than the burning of a light bulb. A thermal cutoff turns the unit off should air flow be impeded.
Key Features of all Air-Dryr Units:
Attractive, neutral beige housing made of polycarbonate for strength and durability
Slim and stable
Can be placed out of the way in confined spaces
Handle a high volume of air
Designed to be left on 24 hours a day
Safe to the touch
Low operating cost
Trouble free
no switch, fan, or thermostat; uses natural convection to circulate the air
Silent operation
Safe for marine use
no components which cause sparking
UL listed
Use at Home or Office
Basements
Closets
Under Desks
Storage Units
Tack Rooms
Pump Rooms
Gun Cabinets
Pianos
Use in RVs
Motor Homes
Trailers Cars Airplanes
Use in Boats
Cabins
Bilges
Engine Rooms
V-Berths
|
47.26 |
|
|
Air Blower 1000 Inline 250 - 24V
7″ in-line mounted marine ventilation 24V axial blower with capacity 1000 m3 per h, 589 CFM. 178mm port connection and 250mm length. Sheltered blades from blower housing interference at tough installation. Compact 5 blade design to maximize performance.
Features:
Weight: 1.4 kg/3 lbs
Dimensions: 250/9.8L x 220/8.7H x 178/7W mm/in
Type: 7" In-Line
For continous duty. 3,5A fuse
Interchangeable with Vetus Vent17824A.
*Certification: CE marked ISO 9097:1991 Marine (small craft electrical fans), ISO8846 1990 (ignition protection), ISO 10133 2000 (electrical systems), EN55014-1 2006 (2004/108EC)
|
200.69 |
|
|
Air Blower 1000 Inline 165 - 12V
7″ in-line mounted marine ventilation 12V axial blower with capacity 1000 m3 per h, 589 CFM. 178mm port connection and 165mm length. Sheltered blades from blower housing interference at tough installation. Compact 5 blade design to maximize performance.
Features:
Weight: 1.2 kg/2 lbs
Dimensions: 165/6.5L x 220/8.7H x 178/7W mm/in
Type: 7" In-Line
For continous duty
7A fuse
*Certification: CE marked ISO 9097:1991 Marine (small craft electrical fans), ISO8846 1990 (ignition protection), ISO 10133 2000 (electrical systems), EN55014-1 2006 (2004/108EC)
|
197.16 |
|
|
Air Blower 1000 Inline 165 - 24V
7″ in-line mounted marine ventilation 24V axial blower with capacity 1000 m3 per h, 589 CFM. 178mm port connection and 165mm length. Sheltered blades from blower housing interference at tough installation. Compact 5 blade design to maximize performance.
Features:
Weight: 1.2 kg/2 lbs
Dimensions: 165/6.5L x 220/8.7H x 178/7W mm/in
Type: 7" In-Line
For continous duty
3,5A fuse
Certification: CE marked ISO 9097:1991 Marine (small craft electrical fans), ISO8846 1990 (ignition protection), ISO 10133 2000 (electrical systems), EN55014-1 2006 (2004/108EC)
|
200.69 |
|
|
Air Blower 1000 In-Line 250 - 12V
7″ in-line mounted marine ventilation 12V axial blower with capacity 1000 m3 per h, 589 CFM. 178mm port connection and 250mm length. Sheltered blades from blower housing interference at tough installation. Compact 5 blade design to maximize performance.
Features:
Weight: 1.4 kg/3 lbs
Dimensions: 250/9.8L x 220/8.7H x 178/7W mm/in
Type: 7" In-Line
For continous duty
7A fuse
Interchangeable with Vetus Vent17812A.
*Certification: CE marked ISO 9097:1991 Marine (small craft electrical fans), ISO8846 1990 (ignition protection), ISO 10133 2000 (electrical systems), EN55014-1 2006 (2004/108EC)
|
197.16 |
|
|
Jabsco 18596-1000 Gasket (Pair)
|
13.43 |
|
|
As the Fall months creep into our calendars, boat owners in cooler climates acknowledge, with sadness, that it’s time to put the boat away.
Outside Storage?
It’s a thought and an option but consider that you may be threatened by snow build up, tornadoes or hurricanes. The success of storing your boat outside depends on how well your boat is protected from the conditions outdoors.
Rinse/Flush
Rinsing the outside of your boat and trailer thoroughly with fresh water will remove excess salt. Pay particular attention to your trailer’s leaf springs, wheel hubs and brakes that are constantly submerged during launching and retrieval of your boat.
Flush your engine's cooling system with fresh water in line with your engine manufacturer’s salt removal recommendations. This will minimize corrosion and overheating issues come spring.
Drain your boat of all water – bilge, head, sink lines, water tanks, sea-cocks, and pipes. If you are in an area with extended periods of freezing, put antifreeze in the low parts if there is still some water present.
Salt
Watch out for salt. Buy a good salt remover to minimize corrosion.
Add fuel stabilizer to top off your fuel tanks. Here is one recommended by CLR Marine.
Diesel Formula Fuel Stabilizer & Performance Improver - 32oz *Case of 4*
STA-BIL Diesel Formula Fuel Stabilizer is a diesel additive that keeps fuel fresh for quick, easy starts and maximized for engine performance. Designed for use with all diesel engines, and all diesel fuels, Sta-Bil Fuel Stabilizer Diesel formula prevents sludge and sediment formation, cleans and lubricates fuel injectors to improve performance and helps remove water. It is safe to use and recommended for use at every fill up, with the 32 ounce bottle treating up to 320 gallons of fuel.
Batteries
Remove the batteries from your boat and store in your garage or basement.
Batteries should be connected to a battery charger that will give them a good charge and one that w automatically switches to a float/trickle charge to keep your batteries topped up. Match your charger to the type of battery you are charging. Using a charger manufactured for lead acid batteries to charge an AGM (absorbent glass mat) battery will cause damage to the battery.
If you choose to keep your batteries in the boat, connect a solar trickle charger. These chargers will keep your batteries topped off without the hassle of removing heavy batteries from your boat.
Cleaning
Clean the exterior with the proper fiber glass or wood cleaner needed for your boat. Bright work can be cleaned by removing the wood or cleaning it as it is - installed. Be careful to not get the wood cleaner onto the deck surfaces. The exterior should be dried with a chamois cloth. Vinyl seat cushions and backs should be cleaned with vinyl cleaner. Hard surfaces inside the vessel can be wiped with all purpose cleaners. End your cleaning with a coat of wax to the exterior and polish. Don’t forget the bottom paint.
Before you store, spend the time to give your boat a thorough cleaning. CLR Marine has many products by trusted brands such as Powerhouse, Davis Instruments, Jabsco, Shurhold, and Swobbit, to help winterize and clean. You will be grateful in the spring during launch time that your boat is already clean as the new boating season begins.
Cover Up
If you store outside in your yard, driveway, or a boat yard, a boat cover is a must to prevent damage from winter conditions. Leaving your boat in the water is not recommended. The boat is exposed to rough weather, and has a greater possibility of sinking if you aren’t monitoring it often.
https://www.clrmarine.com/462m4/boat-outfitting/winter-covers.html
and
https://www.clrmarine.com/462m4/winterizing.html
Circle May 21, 2022, on your calendar. The date is almost ten days before Memorial Day, next year when most harbors open for the season. Start your prep work, tune-ups, sanding, and painting to get out on the water and a great boating season. In the meantime, during the cold winter months, cozy up to the fire and read your boating manuals, new safety regulations and weather information.
Fair winds and smooth sailing.
To obtain more information about the products and services mentioned in this article, please get in touch with CLR Marine https://www.clrmarine.com/.
_________________________________________________________________________
Award-winning author Cheryl Kuba has been at the helm for more than 30 years sailing the Great Lakes, with side trips to the British Virgin Islands and St. Maarten.
She has served as past- Commodore of Great Lakes Fleet 21 -Chicago region. 3happycampers.com
©Copyright Cheryl Kuba, 3happycampers.com, 2021.
|
|
|
AirForce® Quick Draw Portable Pet Dryer - Orange
With this powerful, handheld pet dryer, it’s possible to dry a pet safely in minutes. This dog and cat dryer has a lightweight frame for easy portability.
Catalog Part Number: QD-1
Features:
This pet dryer produces 10 times more blowing power than a human hair dryer, and best of all, it's safe for all pets because there's no heating element to dry out their coats or burn their skin.
Technical Specifications:
Motor: 1.3 HP
Amps: 8.3 AMPS
Watts: 1000 Watts
Airflow: 85 CFM/160 MPH
Cord: 12 in.
Plug: Two (2) prong electrical plugs
Weight: 3.1 pounds
Dimensions (inch): 4.5" x 7.5" x 9.75"
In the Box:
Dryer
6" hose with airflow control
Easy change filter x 1
Air concentrator nozzle
Air flare nozzle
Table mounting hook
Instruction Manual
|
146.00 |
|
|
Air-Flow Tels
Lightweight, ripstop nylon Air-Flow Tels attach to sails with waterproof adhesive locator discs. No holes required. Tels show the air flow across the sails - allowing you to trim sails for maximum performance.
Each kit includes 14 Tels and full instructions on where to apply them and how to read them.
|
10.13 |
|
|
March 0986-0002-1000 Air Motor 1/8 Hp
|
730.00 |
|
|
March 0125-0106-1000 Mounting For 809 Series
March Pump Mounting Bracket for 809 Series Base (Mtr Connecting) for Air Motors 12 & 24 volt only
|
33.48 |
|
|
JABSCO 50640-1000 FITTING 1" HOSE BARB STRAIGHT PORT KIT
Large Format Snap-In Port to 1" (25mm) Hose Barb Straight Port Kit, Pair
|
17.24 |
|
|
JABSCO 50641-1000 FITTING 1" HOSE BARB ELBOW
Jabsco Large Format Snap-In Port to 1" (25mm) Hose Barb Elbow Port Kit, Pair
|
17.24 |
|