SeaTalkng Backbone Extender for extending blue SeaTalkng Backbone Cables.

The SeaTalkng Backbone kit contains everything you need to construct and wire a basic SeaTalkng navigation network backbone on board your vessel. The kit contains the following components: A06031 SeaTalkng Terminators (Qty. 2) A06037 Backbone Cable, 20m A06036 Backbone Cable, 5m (Qty. 2) A06028 T-Piece (Qty. 4) A06049 Network Power Cable 81300 SeaTalkng Reference Manual ST70 Displays, transducer pods, transducers and network spurs are not included.

SeaTalkng Terminators attach at each end of SeaTalk backbone. Two are required per system.

SeaTalkngT-Piece Connector. Used for connecting white SeaTalkng Spur Cables to Blue SeaTalkng Backbone Cables.

5-way SeaTalkng Connector used for connecting spurs to the backbone.

Spur Cable Raymarine 5 meter Spur Cable for SeaTalkng

Spur Cable Raymarine 400MM Spur Cable for SeaTalkng

Spur Cable Raymarine 1 meter Spur Cable for SeaTalkng

Spur Cable Raymarine 3 meter Spur Cable for SeaTalkng

Devicenet Female ADP Cable - SeaTalkng - NMEA 2000 Adapts SeaTalkng to NMEA2000 network. For use with E & C Series Widescreen, G Series, and ST70 systems. Female: 15.7" (0.4m)

Devicenet Male ADP Cable SeaTalkng to NMEA 2000 Adapts SeaTalkng to NMEA2000 network. For use with E & C Series Widescreen, G Series, and ST70 systems. Male: 1.5M cable

Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender.

Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender.

Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender.

Backbone Cables In a SeaTalkng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender.