|
Rule-Mate 2000 GPH 24 Volt Fully Automated Bilge Pump
The Rule-Mate® 2000 GPH pump consists of a powerful Rule® bilge pump and a highly intelligent circuit board in a single housing. The pump activated when the water reaches 2-1/2" and automatically shuts off when the pump senses no water against the impeller, reducing the remaining water to approximately 5/8".
Rule-Mate Intelligence
Rule-Mate Bilge pumps have built-in programming that can sense when the pump is running but not pumping water. This is a very unique feature to bilge pumps because it protects the pump and the vessel, especially the vessels batteries. If debris fouls the sensor or the pump becomes air-bound, the pump will stop running and begin to "check" for water every 2-1/2 minutes. Once the debris is removed, the pump will revert to its normal operation, turning on when the water reaches 2-1/2" and shutting off at 5/8".
2000 GPH (7570 LPH) at 0' (27.2V)
All-in-one pump and switch
Extra long life heavy duty motor
1" NPS discharge with 1" AND 1 1/8" screw-on ports
Three year warranty
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
294.12 |
|
|
Rule-Mate 2000 GPH 12 Volt Fully Automated Bilge Pump
The Rule-Mate® 2000 GPH pump consists of a powerful Rule® bilge pump and a highly intelligent circuit board in a single housing. The pump activated when the water reaches 2-1/2" and automatically shuts off when the pump senses no water against the impeller, reducing the remaining water to approximately 5/8".
Rule-Mate Intelligence
Rule-Mate Bilge pumps have built-in programming that can sense when the pump is running but not pumping water. This is a very unique feature to bilge pumps because it protects the pump and the vessel, especially the vessels batteries. If debris fouls the sensor or the pump becomes air-bound, the pump will stop running and begin to "check" for water every 2-1/2 minutes. Once the debris is removed, the pump will revert to its normal operation, turning on when the water reaches 2-1/2" and shutting off at 5/8".
2000 GPH (7570 LPH) at 0' (13.6V)
All-in-one pump and switch
Extra long life heavy duty motor
1" NPS discharge with 1" AND 1 1/8" screw-on ports
Three year warranty
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
288.71 |
|
|
Rule-Mate 1500 GPH 12 Volt Fully Automated Bilge Pump
The Rule-Mate® 1500 GPH pump consists of a powerful Rule® bilge pump and a highly intelligent circuit board in a single housing. The pump activated when the water reaches 2-1/2" and automatically shuts off when the pump senses no water against the impeller, reducing the remaining water to approximately 5/8".
Rule-Mate Intelligence
Rule-Mate Bilge pumps have built-in programming that can sense when the pump is running but not pumping water. This is a very unique feature to bilge pumps because it protects the pump and the vessel, especially the vessels batteries. If debris fouls the sensor or the pump becomes air-bound, the pump will stop running and begin to "check" for water every 2-1/2 minutes. Once the debris is removed, the pump will revert to its normal operation, turning on when the water reaches 2-1/2" and shutting off at 5/8".
1500 GPH (6819 LPH) at 0' (13.6V)
All-in-one pump and switch
Extra long life heavy duty motor
1" NPS discharge with 1" AND 1 1/8" screw-on ports
Three year warranty
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
224.17 |
|
|
Rule 2000
Non-Automatic 12v, UL listed w/ 6' wire leads
Engineered to commercial standards. The Rule 2000 is the best selling high capacity submersible bilge pump in the world. 1-1/8" (28.6mm) discharge outlet.
FEATURES
Fully Submersible
Easy clean snap lock strainer
Silent and vibrationless operation
Anti-airlock protection
Compact, efficient long life motor
Ignition protected
No burn-out when run dry
Rust and Corrosion protection
Used by leading boatbuilders worldwide
marine grade blocked wiring
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
164.35 |
|
|
Rule 2000
Engineered to commercial standards. The Rule 2000 is the best selling high capacity submersible bilge pump in the world. 1-1/8" (28.6mm) discharge outlet.
FEATURES
Fully Submersible
Easy clean snap lock strainer
Silent and vibrationless operation
Anti-airlock protection
Compact, efficient long life motor
Ignition protected
No burn-out when run dry
Rust and Corrosion protection
Used by leading boatbuilders worldwide
marine grade blocked wiring
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
164.99 |
|
|
Rule 1500
Non-Automatic 24v
High pumping capacity and reliability at a lower cost. The Rule 1500 offers more pumping capacity and more exclusive design features than any comparable competitive pump. 1-1/8" (28.6mm) discharge outlet.
FEATURES
Fully Submersible
Easy clean snap lock strainer
Silent and vibrationless operation
Anti-airlock protection
Compact, efficient long life motor
Ignition protected
No burn-out when run dry
Rust and Corrosion protection
Used by leading boatbuilders worldwide
marine grade blocked wiring
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
121.46 |
|
|
1100GPH Electronic Sensing Bilge Pump - 24V
In the next generation sensing bilge pumps, the 1100GPH 24V S series pump works on the principle of impeller resistance. The pump will turn on every 2-1/2 minutes for about one second to sense for water. If water is present, the pump will sense resistance and continue to run until all water is removed. After that, it will resume checking for water every 2-1/2 minutes.
Water is kept in check between 1/8" and 3/8" Great idea when power conservation is needed and as an added benefit, no float switch is needed!
All that plus the added benefits of our standard bilge pump:
Check valve included with hidden air vent to prevent airlocking
True electromagnetic suppression (EMC)
A built-in thermal cell that protects the pump and the vessel when things get too hot
These are the smallest automatic pumps available on the market!!!
Features:
Completely automatic with manual override - No Float Switch Needed!
Submersible and Ignition Protected
High efficiency, low amp motor
Stainless-steel shaft
Includes backflow preventer
WARNING: This product can expose you to chemicals including 1,3-Butadiene which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
138.59 |
|
|
500GPH Electronic Sensing Bilge Pump - 24V
In the next generation sensing bilge pumps, the 500GPH 24V S series pump works on the principle of impeller resistance. The pump will turn on every 2-1/2 minutes for about one second to sense for water. If water is present, the pump will sense resistance and continue to run until all water is removed. After that, it will resume checking for water every 2-1/2 minutes.
Water is kept in check between 1/8" and 3/8"!!! Great idea when power conservation is needed and as an added benefit, no float switch is needed!
All that plus the added benefits of our standard bilge pump:
Check valve included with hidden air vent to prevent airlocking
True electromagnetic suppression (EMC)
A built-in thermal cell that protects the pump and the vessel when things get too hot
These are the smallest automatic pumps available on the market!!!
Features:
Completely automatic with manual override - No Float Switch Needed!
Submersible and Ignition Protected
High efficiency, low amp motor
Stainless-steel shaft
Includes backflow preventer
WARNING: This product can expose you to chemicals including 1,3-Butadiene which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
93.54 |
|
|
Gianneschi MAXI SUB 24V Submersible Pump 24V
Submersible Bilge Pump for seawater and grey water
Maxi Sub - 24volt
Voltage: 24 V
Power: 0,18 kW
Max flow: 180 L/min @ 2 m
Max head: 8m @ 30 L/min
Outlet: 1", female (vertical)
Stainless steel shaft (AISI 316) ; ABS open impeller
Diameter: 180 mm
Height: 290 mm
IP rating : IP68
|
888.68 |
|
|
Rule 2000
Engineered to commercial standards. The Rule 2000 is the best selling high capacity submersible bilge pump in the world. 1-1/8" (28.6mm) discharge outlet. 12 Volts DC unless noted.
Features:
Fully Submersible
Easy clean snap lock strainer
Silent and vibrationless operation
Anti-airlock protection
Compact, efficient long life motor
Ignition protected
No burn-out when run dry
Rust and Corrosion protection
Used by leading boatbuilders worldwide
marine grade blocked wiring
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
150.30 |
|
|
Rule 2000
Non-Automatic 24V
Engineered to commercial standards. The Rule 2000 is the best selling high capacity submersible bilge pump in the world. 1-1/8" (28.6mm) discharge outlet. 24 Volts DC .
Voltage:24 (Vdc)
Amp Draw: 4 (amp)
Fuse Size:7.5 (amp)
Height:152 (mm) 6 (inches)
Width:108 (mm) 4-1/4 (Inches)
Weight:1.3 (kg) 2-15 (lb)
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
164.35 |
|
|
500GPH Standard Bilge Pump - 24V
Customers talk about flow, they want the water out of the bilge, and
fast. Improved design and performance means that our next generation 500GPH pump will produce this flow at just 24V rather than 27.2V as previously required...more typical of on board voltage supply.
Our next generation of Rule pumps include check valves and to do this, we've created hidden air vent to prevent airlocking. Under each strainer tab there is a small hole that vents any air trapped in the pump housing preventing airlocks...and that's how we do it.
We have true electromagnetic suppression (EMC). We have a built-in thermal cell that protects the pump and the vessel when things get too hot.
We've re-engineered the inside and outside of our bilge pumps, starting with a blank slate. And we're just getting started
Features:
Non-automatic - used with a panel switch or Rule float switch
Submersible and Ignition Protected
High efficiency, low amp motor
Stainless-steel shaft
Includes backflow preventer
WARNING: This product can expose you to chemicals including 1,3-Butadiene which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
35.23 |
|
|
800GPH Standard Bilge Pump - 24V
Customers talk about flow, they want the water out of the bilge, and
fast. Improved design and performance means that our next generation 800GPH pump will produce this flow at just 24V rather than 27.2V as previously required...more typical of on board voltage supply.
Our next generation of Rule pumps include check valves and to do this, we've created hidden air vent to prevent airlocking. Under each strainer tab there is a small hole that vents any air trapped in the pump housing preventing airlocks...and that's how we do it.
We have true electromagnetic suppression (EMC). We have a built-in thermal cell that protects the pump and the vessel when things get too hot.
We've re-engineered the inside and outside of our bilge pumps, starting with a blank slate. And we're just getting started
Features:
Non-automatic - used with a panel switch or Rule float switch
Submersible and Ignition Protected
High efficiency, low amp motor
Stainless-steel shaft
Includes backflow preventer
WARNING: This product can expose you to chemicals including 1,3-Butadiene which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
53.26 |
|
|
HD2000 Heavy Duty Bilge Pump - 24V & 2000 GPH
Heavy-Duty Blige Pumps integrate the highest quality bearings, brushes, alloys, and magnets designed to withstand extreme usage cycles. The pump also employs an exclusive shaft and motor compartment, reducing wear and significantly extending pump life. Advanced resin compositions are incorporated in the exterior to resist chemicals such as engine oil, aggressive detergents, and hose plasticizers. Attwood’s Heavy Duty bilge has unsurpassed durability and efficiency in a compact design to ensure electrical energy is converted to the pump rather than excess heat. Attwood's highest capacity pump, the ball-bearing design provides for cooler motor operation and longer life. Also, this pump delivers over 2000 GPH at open flow while drawing less than 7-amps.
Features:
High-quality bearings, brushes, alloys, and magnets
Advanced resin compositions incorporated into the exterior
Specifications:
Rated Voltage: 24
Fuse Size: 7 Amp
Hose Size: (inch) 1-1/8" inner diameter
|
122.50 |
|
|
Rule 3700
Non-Automatic 32v
Heavy duty construction for both commercial and pleasure boat use; known for trouble free operation and reliability. 1-1/2" (38mm) discharge outlet.
FEATURES
Fully Submersible
Easy clean snap lock strainer
Silent and vibrationless operation
Anti-airlock protection
Compact, efficient long life motor
Ignition protected
No burn-out when run dry
Rust and Corrosion protection
Used by leading boatbuilders worldwide
marine grade blocked wiring
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
257.44 |
|