Dual Station Floating Ground - 400 PSI 1/8-27NPT Features: Ground - Floating  Connection - Knurled Nut Voltage - 6 - 24V Thread - 1/8-27 NPTF Max. Pressure Range - 400 PSI / 25.58 Bar  *Sold as an Individual WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Pressure Sender 150 PSI - 1/8-27 NPT  Features: Ground - Standard Connection - Knurled Nut Voltage - 6-24V Thread - 1/8-27 NPTF Component Reference No. - 29/12 Max. Pressure  - 150 PSI / 10 bar (10-180Ohm)  *Sold as an Individual WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Pressure Sender 80 PSI - 1/8-27 NPTF Features: Ground - Standard Connection - Knurled Nut Voltage - 6-24V Thread - 1/8-27 NPTF Component Reference No. - 29/4 Max. Pressure Range - 80PSI / 5 bar (10-180Ohm) *Sold as an Individual WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Coolant Temperature Sensor - 40°C to 120°C - 1/8 - 27NPTF Features: Measurement Range - 40°C - 120°C Category - Temperature Sensors Signal Analogue - 287.4 - 22.7 Ohm Operating Voltage - 6 - 24 V Temperature medium - Coolant - Water - Air - Engine oil - Transmission oil - Fuel Communication - Analog Signal Output - 287.4 - 22.7 Ohm Sensor Signal - Common Ground Sensor Connector - AMP Male T-Model 6.3 X 0.8 mm Thread1/8" - 27 NPTF Male Warning Contact - None Connector Type - AMP Blade T-Model 6.3 X 0.8 mm *Sold as an Individual This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.

BURKS 350GA6-2-5 1/8, PUMP AND MOTOR UNSPSC Code: 40150000

Groco 1/8 Square Key 1/8 Square Key  

Goulds 16Bfk1 - 5 1/8 Kit W/ 5 1/8 Trim  

Bosworth 74  1 1/8" Check Valve   Bosworth Foot Valve / Check Valve Sea-Lect Gray Delrin, Buna Flapper Valve, 1 1/8" Smooth Hose Ports

Bosworth 74-B-1/8  1 1/8" Barb   Bosworth Foot Valve / Check Valve Sea-Lect Gray Delrin, Buna Flapper Valve, 1 1/8” Hose Barb

Temperature Sensor 240° F - 1/8-27NPTF All Temperature sensors are designed to work with VDO gauges only. Sensors are matched to gauges according to maximum reading on dial face. All sensors are standard ground (sensor case to common ground).  Please note: VDO sensors have tapered threads and DO NOT require the use of Teflon tape or pipe sealant. This will interfere with grounding causing incorrect instrument readings.  Features: Marine 240°/250°F Temperature Sender 1/8-27 NTPF Threads All brass construction #8-32 Connection Works with most standard marine temperature gauges *Sold as an Individual WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

FINISH THOMPSON A101761-1 PVDF IMPELLER 6 1/8"

As the Fall months creep into our calendars, boat owners in cooler climates acknowledge, with sadness, that it’s time to put the boat away. Outside Storage? It’s a thought and an option but consider that you may be threatened by snow build up, tornadoes or hurricanes. The success of storing your boat outside depends on how well your boat is protected from the conditions outdoors.                          Rinse/Flush Rinsing the outside of your boat and trailer thoroughly with fresh water will remove excess salt. Pay particular attention to your trailer’s leaf springs, wheel hubs and brakes that are constantly submerged during launching and retrieval of your boat. Flush your engine's cooling system with fresh water in line with your engine manufacturer’s salt removal recommendations. This will minimize corrosion and overheating issues come spring. Drain your boat of all water – bilge, head, sink lines, water tanks, sea-cocks, and pipes. If you are in an area with extended periods of freezing, put antifreeze in the low parts if there is still some water present. Salt Watch out for salt. Buy a good salt remover to minimize corrosion. Add fuel stabilizer to top off your fuel tanks. Here is one recommended by CLR Marine. Diesel Formula Fuel Stabilizer & Performance Improver - 32oz *Case of 4* STA-BIL Diesel Formula Fuel Stabilizer is a diesel additive that keeps fuel fresh for quick, easy starts and maximized for engine performance. Designed for use with all diesel engines, and all diesel fuels, Sta-Bil Fuel Stabilizer Diesel formula prevents sludge and sediment formation, cleans and lubricates fuel injectors to improve performance and helps remove water. It is safe to use and recommended for use at every fill up, with the 32 ounce bottle treating up to 320 gallons of fuel. Batteries Remove the batteries from your boat and store in your garage or basement. Batteries should be connected to a battery charger that will give them a good charge and one that w automatically switches to a float/trickle charge to keep your batteries topped up. Match your charger to the type of battery you are charging. Using a charger manufactured for lead acid batteries to charge an AGM (absorbent glass mat) battery will cause damage to the battery. If you choose to keep your batteries in the boat, connect a solar trickle charger. These chargers will keep your batteries topped off without the hassle of removing heavy batteries from your boat. Cleaning Clean the exterior with the proper fiber glass or wood cleaner needed for your boat. Bright work can be cleaned by removing the wood or cleaning it as it is - installed. Be careful to not get the wood cleaner onto the deck surfaces. The exterior should be dried with a chamois cloth. Vinyl seat cushions and backs should be cleaned with vinyl cleaner. Hard surfaces inside the vessel can be wiped with all purpose cleaners. End your cleaning with a coat of wax to the exterior and polish. Don’t forget the bottom paint. Before you store, spend the time to give your boat a thorough cleaning. CLR Marine has many products by trusted brands such as Powerhouse, Davis Instruments, Jabsco, Shurhold, and Swobbit, to help winterize and clean. You will be grateful in the spring during launch time that your boat is already clean as the new boating season begins. Cover Up If you store outside in your yard, driveway, or a boat yard, a boat cover is a must to prevent damage from winter conditions. Leaving your boat in the water is not recommended. The boat is exposed to rough weather, and has a greater possibility of sinking if you aren’t monitoring it often. https://www.clrmarine.com/462m4/boat-outfitting/winter-covers.html and https://www.clrmarine.com/462m4/winterizing.html Circle May 21, 2022, on your calendar. The date is almost ten days before Memorial Day, next year when most harbors open for the season. Start your prep work, tune-ups, sanding, and painting to get out on the water and a great boating season. In the meantime, during the cold winter months, cozy up to the fire and read your boating manuals, new safety regulations and weather information. Fair winds and smooth sailing.   To obtain more information about the products and services mentioned in this article, please get in touch with CLR Marine https://www.clrmarine.com/. _________________________________________________________________________ Award-winning author Cheryl Kuba has been at the helm for more than 30 years sailing the Great Lakes, with side trips to the British Virgin Islands and St. Maarten. She has served as past- Commodore of Great Lakes Fleet 21 -Chicago region. 3happycampers.com ©Copyright Cheryl Kuba, 3happycampers.com, 2021.  

Rudder Angle Sender Single Station - Standard or Floating Ground Faria sending unit transmits a signal to indicate the current rudder position to a single rudder angle gauge. This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.

Pressure Sender 400 PSI Floating Ground - 1/8-27 NPT  Features: Ground - Floating Connection - Knurled Nut Voltage - 6-24V Thread - 1/8-27 NPTF Component Reference No. - 38/8 Max. Pressure Range - 400PSI / 28 bar (10-180Ohm) *Sold as an Individual WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Ray63 Dual Station VHF Radio with GPS Raymarine’s Ray63 radio comes with oversized controls and a big screen for easy operation offshore.  Ray63 is a full-function VHF marine radio with Class D Digital Selective Calling (DSC) and a built-in GPS receiver.  Simply program your boat’s MMSI number into the Ray63 and immediately benefit from the enhanced calling and safety features of DSC.  The Ray63 supports both NMEA2000 and legacy NMEA0183 networking which enables it to connect with other onboard electronics.  Ray63 also supports the connection of an optional remote speaker (A80542) to provide audio at a second location. Ray63 also supports dual control stations with the addition of the optional RayMic second station kit.  With an oversized LCD and simple controls, the RayMic is a compact all-in-one handset that fits easily on any secondary helm, tower or navigation station. Use RayMic for station-to-station intercom capability too.  Ray63 was designed to comply with the latest international regulations and includes a connection point for an optional GPS/GNSS antenna.  The optional antenna improves the GPS reception when the radio is mounted below deck, in an enclosed pilothouse, or inside a metal enclosure. Ray63 features an attractive industrial design that complements Raymarine’s Axiom family multifunction displays.  The radio includes both a standard trunnion mounting kit as well as surface mounting hardware. Features: Full-sized marine VHF with Digital Selective Calling Optional RayMic second station kit for full remote control Built-in GPS/GNSS receiver with an optional external antenna connection Surface and trunnion mount kits included Compliments the style and design of Axiom multifunction displays