Twin Mini Compact Horn  Twin Mini Compact Horn features a prewired, sealed sound unit with 304 stainless steel diaphragm and stamped 304 stainless cover. Mounting bracket can be used as a wiring template. A drop-in replacement for many common OEM horns. When installed, horns should point slightly downward to permit water drainage. At 111 decibels and a frequency (Hz) of 490±20A, this horn meets US Coast Guard's COLREGS and ABYC standard A-23 for use on vessels under 12m (39'). 12VDC. NMMA Type Accepted #2577061.

Max Blast Twin Mini Compact Horn  MaxBlast Twin Mini Compact Horn is constructed of injection molded housing under the stamped 304 stainless steel cover, which protects the the internal components from corrosion. After a 600 hour salt spray test, this electric horn was completely rust-free! Mounting bracket can be used as a wiring template. When installed, horns should point slightly downward to permit water drainage. At 111 decibels and a frequency (Hz) of 490±20A, this horn meets US Coast Guard's COLREGS and ABYC standard A-23 for use on vessels under 12m (39'). 12VDC. Five-year rust-free warranty. 12VDC. NMMA Type Accepted #2577062. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Single Mini Compact Horn  Single Mini Compact Horn features a prewired, sealed sound unit with 304 stainless steel diaphragm and stamped 304 stainless cover. Mounting bracket can be used as a wiring template. A drop-in replacement for many common OEM horns. When installed, horns should point slightly downward to permit water drainage. At 108 decibels and a frequency (Hz) of 440±20A, this horn meets US Coast Guard's COLREGS and ABYC standard A-23 for use on vessels under 12m (39'). 12VDC. NMMA Type Accepted #2577059. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Sonic Mini Compact Horn - Chrome  These Sonic Mini Compact Horns feature ASA plastic covers for impact and UV resistance. Mounting bracket can be used as a wiring template. Horn wiring has no polarity, so the negative or positive wire can be attached to either side. When installed, horns should point slightly downward to permit water drainage. At 108 decibels and a frequency (Hz) of 440±20A, this horn meets US Coast Guard's COLREGS and ABYC standard A-23 for use on vessels under 12m (39'). 12VDC. 12VDC. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Sonic Mini Compact Horn - White  These Sonic Mini Compact Horns feature ASA plastic covers for impact and UV resistance. Mounting bracket can be used as a wiring template. Horn wiring has no polarity, so the negative or positive wire can be attached to either side. When installed, horns should point slightly downward to permit water drainage. At 108 decibels and a frequency (Hz) of 440±20A, this horn meets US Coast Guard's COLREGS and ABYC standard A-23 for use on vessels under 12m (39'). 12VDC. 12VDC. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Sonic Mini Compact Horn - Black  These Sonic Mini Compact Horns feature ASA plastic covers for impact and UV resistance. Mounting bracket can be used as a wiring template. Horn wiring has no polarity, so the negative or positive wire can be attached to either side. When installed, horns should point slightly downward to permit water drainage. At 108 decibels and a frequency (Hz) of 440±20A, this horn meets US Coast Guard's COLREGS and ABYC standard A-23 for use on vessels under 12m (39'). 12VDC. 12VDC. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Pontoon Boat Mini Compact Horn with Bracket  Pontoon Boat Mini Compact Horn with Bracket is constructed of powder coated steel. Includes 304 stainless steel bracket for easy mounting. Recommended for fresh water applications. At 111 decibels and a frequency (Hz) of 370±20A, this horn meets US Coast Guard's COLREGS and ABYC standard A-23 for use on vessels under 12m (39'). 12VDC. NMMA Type Accepted #2601746.

Max Blast Single Mini Compact Horn  Max Blast Single Mini Compact Horn is constructed of injection molded housing under the stamped 304 stainless steel cover, which protects the internal components from corrosion. After a 600 hour salt spray test, this electric horn was completely rust-free! Mounting bracket can be used as a wiring template. When installed, horns should point slightly downward to permit water drainage. At 108 decibels and a frequency (Hz) of 440±20A, this horn meets US Coast Guard's COLREGS and ABYC standard A-23 for use on vessels under 12m (39'). 12VDC. Five-year rust-free warranty. 12VDC. NMMA Type Accepted #2577060. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Hidden Mount Mini Compact Horn  Hidden Mount Mini Compact Horn is constructed of powder coated steel. At 107 decibels and a frequency (Hz) of 440±20A, this horn meets US Coast Guard's COLREGS and ABYC standard A-23 for use on vessels under 12m (39'). 12VDC. NMMA Type Accepted #2577068. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

ATM Mini Style Inline LED Fuse Holder - Up to 30A This Sea-Dog LED inline mini fuse holder is meant for ATM mini-style fuses. Features: LED indicator that lights up when the fuse is blown Designed to accept ATM mini automotive-style spade terminal fuses For use with Sea-Dog ATM Mini Style Fuses 445002-445030 (sold separately). 12 gauge, 6” AWM wire lead Constructed of injection-molded PVC. IP67 waterproof rating Specifications: Max Amps: 30 Fuse Holder Length: 1-9/16 in. Fuse Holder Width: 15/16 in.

As the Fall months creep into our calendars, boat owners in cooler climates acknowledge, with sadness, that it’s time to put the boat away. Outside Storage? It’s a thought and an option but consider that you may be threatened by snow build up, tornadoes or hurricanes. The success of storing your boat outside depends on how well your boat is protected from the conditions outdoors.                          Rinse/Flush Rinsing the outside of your boat and trailer thoroughly with fresh water will remove excess salt. Pay particular attention to your trailer’s leaf springs, wheel hubs and brakes that are constantly submerged during launching and retrieval of your boat. Flush your engine's cooling system with fresh water in line with your engine manufacturer’s salt removal recommendations. This will minimize corrosion and overheating issues come spring. Drain your boat of all water – bilge, head, sink lines, water tanks, sea-cocks, and pipes. If you are in an area with extended periods of freezing, put antifreeze in the low parts if there is still some water present. Salt Watch out for salt. Buy a good salt remover to minimize corrosion. Add fuel stabilizer to top off your fuel tanks. Here is one recommended by CLR Marine. Diesel Formula Fuel Stabilizer & Performance Improver - 32oz *Case of 4* STA-BIL Diesel Formula Fuel Stabilizer is a diesel additive that keeps fuel fresh for quick, easy starts and maximized for engine performance. Designed for use with all diesel engines, and all diesel fuels, Sta-Bil Fuel Stabilizer Diesel formula prevents sludge and sediment formation, cleans and lubricates fuel injectors to improve performance and helps remove water. It is safe to use and recommended for use at every fill up, with the 32 ounce bottle treating up to 320 gallons of fuel. Batteries Remove the batteries from your boat and store in your garage or basement. Batteries should be connected to a battery charger that will give them a good charge and one that w automatically switches to a float/trickle charge to keep your batteries topped up. Match your charger to the type of battery you are charging. Using a charger manufactured for lead acid batteries to charge an AGM (absorbent glass mat) battery will cause damage to the battery. If you choose to keep your batteries in the boat, connect a solar trickle charger. These chargers will keep your batteries topped off without the hassle of removing heavy batteries from your boat. Cleaning Clean the exterior with the proper fiber glass or wood cleaner needed for your boat. Bright work can be cleaned by removing the wood or cleaning it as it is - installed. Be careful to not get the wood cleaner onto the deck surfaces. The exterior should be dried with a chamois cloth. Vinyl seat cushions and backs should be cleaned with vinyl cleaner. Hard surfaces inside the vessel can be wiped with all purpose cleaners. End your cleaning with a coat of wax to the exterior and polish. Don’t forget the bottom paint. Before you store, spend the time to give your boat a thorough cleaning. CLR Marine has many products by trusted brands such as Powerhouse, Davis Instruments, Jabsco, Shurhold, and Swobbit, to help winterize and clean. You will be grateful in the spring during launch time that your boat is already clean as the new boating season begins. Cover Up If you store outside in your yard, driveway, or a boat yard, a boat cover is a must to prevent damage from winter conditions. Leaving your boat in the water is not recommended. The boat is exposed to rough weather, and has a greater possibility of sinking if you aren’t monitoring it often. https://www.clrmarine.com/462m4/boat-outfitting/winter-covers.html and https://www.clrmarine.com/462m4/winterizing.html Circle May 21, 2022, on your calendar. The date is almost ten days before Memorial Day, next year when most harbors open for the season. Start your prep work, tune-ups, sanding, and painting to get out on the water and a great boating season. In the meantime, during the cold winter months, cozy up to the fire and read your boating manuals, new safety regulations and weather information. Fair winds and smooth sailing.   To obtain more information about the products and services mentioned in this article, please get in touch with CLR Marine https://www.clrmarine.com/. _________________________________________________________________________ Award-winning author Cheryl Kuba has been at the helm for more than 30 years sailing the Great Lakes, with side trips to the British Virgin Islands and St. Maarten. She has served as past- Commodore of Great Lakes Fleet 21 -Chicago region. 3happycampers.com ©Copyright Cheryl Kuba, 3happycampers.com, 2021.  

All-Stainless Mini Compact Twin Horn - 12V  Features: All Stainless Steel Inside & Out 304 Stainless Steel inside and out including a sealed sound unit No rust Guaranteed for 5 years. All meet ABYC A-23 for boats up to 12 meters Pre-wired It fits existing hole patterns Specifications: Dimensions: 3"L, 8"W, 1-3/4"H (7.5 x 20.5 x 4.5 cm) Max Amp Draw:6 Amps Rating: 112 dB @ 1 Meter

Mini Compact Twin Horn - 12V  Features: 304 Stainless Steel Trumpets, Diaphragm, and Mounting Brackets Meets ABYCA-23 for boats up to 12 meters Pre-wired Fits existing hole patterns Much louder than competitive models Specifications: Dimensions: 3"L, 8"W, 1-3/4"H (7.5 x 20.5 x 4.5 cm) Max Amp Draw: 6 Amps Rating: 112 db@ 1 Meter

12V Mini Twin Comapct Electric Horn The Mini Twin Electric Horn has two totally sealed sound units with type 304 stainless steel covers, diaphragms and mounting bracket. Features: Dimensions: 3" L x 8" W x 1.75" H Maximum amp draw: 6 amps, 12 volts dB(A) rating: 109 at one meter Fundamental frequency: 490 +/- 20; 430+/-20Hz

12V Mini Compact Electric Horn The Mini Compact Electric Horn has a totally sealed sound unit with type 304 stainless steel cover, diaphragm and mounting bracket. Features: Dimensions: 3" L x 3.25" W x 1.75" H Maximum amp draw: 3 amps, 12 volt dB(A) rating: 106 at one meter Fundamental frequency: 430 +/- 20Hz