RAYMARINE EV-100 WHEEL PILOT $ave lots of money by using two different discounts, first the Discount code is EV100 enter that when checking out, and then go to our Rebate Page and save another $400.00 in rebates.  This coupon code is good until 04-28-2017         The EV Sensor Core At the center of every Evolution system is the intelligent EV sensor core, a 9-axis sensor that monitors vessel motion in all three dimensions. The innovative EV sensor core combines advanced solid-state sensors with the Evolution autopilot processor into a single easy-toinstall housing. Mount the EV sensor core above or below decks, the rugged enclosure is fully sealed and built to IPX6 and IPX7 waterproofing and submersion standards. The EV-1 is designed for Evolution mechanical and hydraulic autopilot systems. SeaTalkng networking enables a single cable connection for power and data to the Evolution ACU (actuator control unit) and extended SeaTalkng and NMEA2000 networks. Features: Precision monitoring of heading, pitch, roll, and yaw allowing the autopilot to evolve instantly as sea conditions and vessel dynamics change Flexible installation options. Mount above or below deck Simple SeaTalkng connectivity to the control head and ACU Solid state sensor technology delivers dynamic accuracy to within 2 degrees in all conditions Fast and reliable heading data for MARPA, radar overlay, and heading modes on Raymarine multifunction displays p70 Autopilot Control Head The p70 is a push-button operation controller designed primarily for sailboats. Features: LightHouse user interface is simple and quick to use Wide 160° viewing angles Start up wizard helps you configure the pilot quickly and easily Anti-reflective coating for improved visibility in bright sunlight Low power - typically 132mA/1.6W - 27% less than ST70 at x4 measured brightness Supported autopilot modes: Auto; Standby; Pattern; Track; Wind Vane; Power Steer and Jog Steer Simple system and group dimming/illumination Support for multiple data sources SeaTalkng/NMEA2000 and SeaTalk1 connectivity (no bridging required) EV-100 Wheel Evolution Autopilot Features: A complete autopilot-in-a-box Evolution Ai for superior performance No calibration required Quick and easy installation Fits most types of sailboat wheels Simple, robust clutch engagement For boats up to 16,500 lbs (7,500 kg) For 12V DC power systems Includes p70 Autopilot Controller Includes: EV-1 Sensor Core p70 Autopilot Control Head ACU-100 Actuator Control Unit Wheel Drive Evolution Cabling Kit EV Unit O-Ring Pack (set of 2) Wall Mounting Bracket    

SS Steering Wheel Maneuvering Knob  Sea-Dog® Steering Wheel Maneuvering Knob fits our Sea-Dog® Steering Wheels (230111, 230212, 230115, 230211, 230215, 230313, and 230315). A steering knob attaches to the wheel for use in situations where maneuvering is excessive. It allows the driver to turn the steering wheel more quickly. Constructed of investment cast stainless steel for corrosion resistance this knob is designed for use with 1" x 3/4" oval tubing.

Evo Pro 316 Cast Stainless Steel Steering Wheel with Control Knob - 13.5" Diameter  Boat owners shouldn't have to sacrifice comfort for elegant styling in a steering wheel. With a gleaming stainless steel center spoke, ergonomic polyurethane grip, and control knob, Schmitt Marine's Model 724 Evo Pro wheel provides the best of both worlds. Combining solid value with a luxurious appearance, the Evo Pro offers features owners expect in more expensive wheels. Cast 316 stainless steel construction ensures strength and durability. Molded to simulate fine hand-stitched leather, the poly grip contributes a plush look as well as optimal ease and handling. Its contrasting combination of materials gives the Evo Pro a smart, sporty look, with a black hand grip, center cap, and control knob setting off the high polish of the stainless steel. The control knob itself eliminates the need for hand-over-hand steering, allowing greater precision and control. Easy to mount, the Evo Pro has a 3/4" tapered shaft and has 13-1/2" wheel diameter. Schmitt Marine thoroughly tests each of its stainless steel wheels and offers a lifetime warranty.

Evo Pro 316 Cast Stainless Steel Steering Wheel with Control Knob - 15.5" Diameter  Boat owners shouldn't have to sacrifice comfort for elegant styling in a steering wheel. With a gleaming stainless steel center spoke, ergonomic polyurethane grip, and control knob, Schmitt Marine's Model 724 Evo Pro wheel provides the best of both worlds. Combining solid value with a luxurious appearance, the Evo Pro offers features owners expect in more expensive wheels. Cast 316 stainless steel construction ensures strength and durability. Molded to simulate fine hand-stitched leather, the poly grip contributes a plush look as well as optimal ease and handling. Its contrasting combination of materials gives the Evo Pro a smart, sporty look, with a black hand grip, center cap, and control knob setting off the high polish of the stainless steel. The control knob itself eliminates the need for hand-over-hand steering, allowing greater precision and control. Easy to mount, the Evo Pro has a 3/4" tapered shaft and has 15-1/2" wheel diameter. Schmitt Marine thoroughly tests each of its stainless steel wheels and offers a lifetime warranty.

V46 - 13.5" Stainless Steel Steering Wheel with Speed Knob - Black Features: Speed knob included All black, including the speed knob Steering wheels are CE marked in conformity with the EN 28848 – EN 29775 and ABYC P22 safety standards Specifications: Diameter: (inch) 13.5" Material: Stainless steel 3 spokes *Note: Wheel nut is not included and is needed for installation 

V46 - 13.5" Stainless Steel Steering Wheel with Speed Knob Features: Polished stainless steel Speed knob included Steering wheels are CE marked in conformity with the EN 28848 – EN 29775 and ABYC P22 safety standards Specifications: Diameter: (inch) 13.5" 3 spokes *Note: Wheel nut is not included and is needed for installation

Faux Center Nut Black with 1/2" & 5/8" M12 Base for Cast Steering Wheels Replacement center cap for Cast Steering Wheels

Evo Pro 316 Cast Stainless Steel Steering Wheel - 13.5" Diameter  Boat owners shouldn't have to sacrifice comfort for elegant styling in a steering wheel. With a gleaming stainless steel center spoke and ergonomic polyurethane grip, Schmitt Marine's Model 724 Evo Pro wheel provides the best of both worlds. Combining solid value with a luxurious appearance, the Evo Pro offers features owners expect in more expensive wheels. Cast 316 stainless steel construction ensures strength and durability. Molded to simulate fine hand-stitched leather, the poly grip contributes a plush look as well as optimal ease and handling. Its contrasting combination of materials gives the Evo Pro a smart, sporty look, with a black hand grip and center cap setting off the high polish of the stainless steel. Easy to mount, the Evo Pro has a 3/4" tapered shaft and has a diameter of 13-1/2". Schmitt Marine thoroughly tests each of its stainless steel wheels and offers a lifetime warranty.

16" Stainless Steel Comfort Grip Steering Wheel - 3/4" - Tapered Shaft Edson's ComfortGrip Power Wheels feature an ergonomically-designed rubber finger grip insert that provides precise control and exceptional comfort.

5/8" Center Nut for 7XX Series Steering Wheels for Teleflex Helms Features: Stainless Steel Center Nut Fits Teleflex Helms

12mm Center Nut for 7XX Series Steering Wheels for Uflex Helms Features: Stainless Steel Construction Fits Uflex Helms

Faux Center Nut - Stainless Steel - 1/2" & 5/8" M12 Base Included for Cast Steering Wheels Features: A lighter-weight nut with the same durability as our standard stainless steel center nuts Unique design allows for Universal fit

Faux Center Nut - Chrome/Plastic - 1/2" & 3/4" Base for Cast Steering Wheels The look of Stainless Steel at a fraction of the cost. Made with Chrome ABS Plastic.

V46 - 13.5" Stainless Steel Steering Wheel with Speed Knob & Chrome Nut Features: Speed knob and nut included Polished stainless steel Steering wheels are CE marked in conformity with the EN 28848 – EN 29775 and ABYC P22 safety standards Specifications: Diameter: (inch) 13.5" 12mm Wheel Nut - 1.75mm thread pitch 3 spokes

V46 - 13.5" Stainless Steel Steering Wheel with Speed Knob & Chrome Nut - Black Features: Speed knob and nut included All black, including the speed knob & chrome nut Steering wheels are CE marked in conformity with the EN 28848 – EN 29775 and ABYC P22 safety standards Specifications: Diameter: (inch) 13.5" 12mm Wheel Nut - 1.75mm thread pitch Material: Stainless steel 3 spokes