|
Xtreme Power Assist Steering is engineered to bring the smooth, easy control of electric power-assisted steering to a wide range of popular boats, including pontoons, runabouts, RIBS, aluminum fishing boats and center consoles without increasing the load on mechanical steering helm or cable. Steering effort is significantly reduced, providing a car-like driving experience. Once installed, the mechanical steering cable only turns the power assist unit, while the electric steering actuator actually turns the engine load. Engineered to fit a wide range of single engine, mechanically steered outboard boats from 90-200HP. Self-contained, plug-and-play system easily mounts to all major outboard brands and integrates with the boats existing mechanical steering. Built in Fail-Safe System automatically reverts to mechanical steering in the event of a system failure.
|
1999.99 |
|
|
Pro Rack features patented NFB technology and twin cables to handle the steering loads in single non-power assisted outboards with top speeds above 50 MPH. Back mount design for easy installation. Fits the standard SeaStar Rack & Pinion cutout, so no dash modifications required when upgrading an existing rack system. Fits boats to 24'. Standard 3/4" tapered steering shaft. Stainless steel telescopic ram. Wheel not included.
|
859.99 |
|
|
Oberdorfer N991-32-C82-W Brz Gear Pump W/12/24V Mtr
|
1896.34 |
|
|
Dramatically reduces wheel torque which reduces steering effort. Reverts to manual mode in the case of power loss. Suitable for use with autopilots. Wall or floor mount. May be used with O/B, I/O, I/B powered boats equipped with standard hydraulic steering. Supplied with 15' wire harness. Both 12V and 24V systems are automatically recognized by the unit. Requires HA1206 fuse kit (sold separately) for ABYC compliance when connecting the PA1200-2 directly to the battery.
|
2694.99 |
|
|
Precision 4.0 turn steering performance with patented NFB technology. Designed for the demanding steering loads of today's high horsepower outboards. Fits standard SeaStar rack & pinion dash cutout with no modification required. Back mount design for easy installation. Fits single non-power assisted outboards up to V4; speeds to 50 MPH. Fits boats up to 24'. Standard 3/4" tapered steering shaft. Stainless steel telescopic arm.
|
419.99 |
|
|
HIT Hydrostatic Inflatable PFD w/Sailing Harness - Red/Black - Automatic/Manual
This front entry PFD automatically inflates when submerged in 4” or more water pressure and features an integrated sailing harness for serious sailors. The lightweight 500D Cordura® outer shell is durable, and the neoprene collar provides all-day comfort. Heavy-duty stainless steel D-rings built into the front of the vest can attach to safety tethers.
The exclusive Hammar® Hydrostatic Inflator Technology (HIT) deploys only when submerged and not when hit with rain, spray, or humidity. The SecureZip stays closed during high winds but opens easily on inflation. A convenient window lets you check the indicator status, and you can also use the manual handle or oral tube to inflate the PFD at any time. The water-resistant pocket secures and protects your essentials. A whistle, strobe light holder, and SOLAR reflective tape all ensure additional on-the-water safety.
*Upon inflation, it is essential to inspect and re-arm your PFD before next use.
Features:
Front entry with buckle for convenient donning and doffing
Durable 500D Cordura® outer shell with reflective accents
Neoprene Comfort Collar prevents chaffing
SecureZip closure
Indicator window to check status (green means it's ready to go)
Hydrostatic Inflator Technology (HIT) only inflates when submerged in 4” or more of water pressure
Manual inflation handle allows you to inflate the vest at any time
Oral inflation tube for backup
Water-resistant pocket
Two heavy-duty stainless steel D-rings for use with tethers
Includes safety whistle for emergencies
SOLAS reflective tape on inflation cell enhances visibility in low light conditions
Holder for a strobe light
Certifications:
U.S.C.G. - Marine Buoyant Devices 160.076 - Type V Recreational
Technical Specifications:
Color - Red/Black
Inflation - Automatic/Manual
CO2 Cylinder Size - 33 gram
Size - Universal Adult
Chest Size - 30" to 52" (76 to 132 cm)
Weight Capacity - ≥ 80 lb (≥36 kg)
*Sold as an Individual
WARNING: This product can expose you to chemicals including ANTIMONY OXIDE (ANTIMONY TRIOXIDE),N,N-Dimethylformamide which are known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
|
359.99 |
|
|
Baystar Hydraulic Steering System for single-outboard powered boats rated up to 150 HP, including runabouts and inflatables, and outboard engines with ABYC standard engine tilt tubes. For single station, single engine use only. BayStar is not intended for high speed, high performance type boats, such as bass boats. Low friction hydraulic steering system, 5 turns lock-to-lock. Balanced cylinder with compact design that fits most splashwells and provides full engine movement. Compact helm with small footprint, requires only 3" dash hole (standard or tilt).Packaged complete with helm, cylinder, fittings, tubing, oil, fill kit and detailed instructions. Standard 3/4" tapered steering shaft. Meets ABYC standards and NMMA certification requirements. Baystar Steering System is not for use on pontoon boats.
|
988.99 |
|
|
Designed for single, non-power-assisted outboard configurations up to 350 hp, especially those capable of speeds over 65 mph, with options like jack plates and performance props. Features No Feedback steering lock valves, low friction hydraulic steering system with ORB fittings on helm and cylinder, 4.0 turns lock to lock. Meets NMMA and ABYC requirements. Refer to application guide below to determine compatibility. Order HO57XX hoses, sold separately.
|
1783.99 |
|
|
Designed for single, non-power-assisted outboard configurations up to 350 hp, especially those capable of speeds over 65 mph, with options like jack plates and performance props. Features No Feedback steering lock valves, low friction hydraulic steering system with ORB fittings on helm and cylinder, 4.0 turns lock to lock. Meets NMMA and ABYC requirements. Refer to application guide below to determine compatibility. Order HO57XX hoses, sold separately.
|
269.99 |
|
|
Pro Rack features patented NFB technology and twin cables to handle the steering loads in single non-power assisted outboards with top speeds above 50 MPH. Back mount design for easy installation. Fits the standard SeaStar Rack & Pinion cutout, so no dash modifications required when upgrading an existing rack system. Fits boats to 24'. Standard 3/4" tapered steering shaft. Stainless steel telescopic ram. Wheel not included.
|
869.99 |
|
|
Pro Rack features patented NFB technology and twin cables to handle the steering loads in single non-power assisted outboards with top speeds above 50 MPH. Back mount design for easy installation. Fits the standard SeaStar Rack & Pinion cutout, so no dash modifications required when upgrading an existing rack system. Fits boats to 24'. Standard 3/4" tapered steering shaft. Stainless steel telescopic ram. Wheel not included.
|
879.99 |
|
|
Baystar Plus Hydraulic Steering System for single-outboard powered boats including runabouts, inflatables and outboard engines with ABYC standard engine tilt tubes up to 150 HP (total). Single station, single engine use only. BayStar is not intended for high speed, high performance type boats, such as bass boats. Low friction hydraulic steering system, 5 turns lock-to-lock. Balanced cylinder with compact design that fits most splashwells and provides full engine movement. Compact Baystar Plus helm with 5" footprint, requires only 3" dash hole (standard or tilt). Packaged complete with helm (HH4514-3), cylinder, fittings, oil, fill kit and detailed instructions. Meets ABYC standards and NMMA certification requirements. Order HO51XX hoses, sold separately.
|
1002.99 |
|
|
Single cable rotary steering system features the Patented "Quick Connect" cable with standard 3/4" shaft and stainless steel output ends. Three turns lock-to-lock, easy installation with no-tools-required cable connection. For use on all power assisted stern drive boats with wheels up to 16" dia. Replaces all Safe-T helms made since 1968 with little or no dash modification. Package includes Safe-T™ QC single helm, QC cable and 90 degree Safe-T™ QC bezel.
|
247.99 |
|
|
Optional tilt helms for Safe-T QC steering systems. 48° of total adjustment in 5 - 12° increments. Kit includes tilt helm and tilt mechanism.
|
213.99 |
|
|
Fits boats up to 24', non power assisted outboard. Back mount design for easy installation. Replaces standard SeaStar Rack & Pinion without dash modification. Pre-assembled Rack & Cable. 4 turns lock-to-lock. Standard 3/4" tapered shaft. Stainless steel telescopic arm.
|
259.99 |
|